Nuance Audio Remote Plus setup

Quick Setup & Use
- Prepare: Remove the battery tab from the Remote before proceeding.
- Pairing (if needed): When the glasses are on and worn, press and hold the + or − volume button on the frame until the blue LED blinks. Then press the side button and hold for 8 seconds.
- Enter setup mode: Press and hold both (+) and (−) for 2 seconds.
- Select language: Hear languages, scroll with +/−, and confirm with the top button.
- Calibrate: Repeat the on-glasses sequence “1, 2, 3, 4.” Then repeat “1, 2, 3, 4” as prompted for own-voice calibration and continue until completed.
- Finish: Setup is complete once enough data has been collected.
- Optional navigation: Next language (+); previous language (−); exit setup by pressing and holding the side button for 2 seconds.
- During use: Volume up (+) / volume down (−). Switch audio mode with the top button.
Remote Plus guided onboarding
Setup Flow
- The Remote Plus is used to activate and set up your eyewear.
- It guides you through onboarding, lets you choose your preferred language, and helps you through a quick personal calibration so everything feels just right for you.

Get ready
- Glasses and Remote Plus are paired
- Glasses are on and worn
- Quiet room
Pairing options
- Pre-paired hard bundle
- Store Associate pairs in store
- User pairs at home
Enter setup mode
- Press and hold +/- buttons
Glasses measure environmental noise to proceed
Select language
- Hear languages
- Scroll with +/-
- Confirm with top button
Audio prompts are used for calibration feedback
Calibrat
- Glasses:
“Repeat after me: 1, 2, 3, 4” - User: “1, 2, 3, 4”
- Continue…
Audio prompts are used for calibration feedback
User voice is used for own-voice calibration
Done
- Setup complete once enough data has been collected
Frame Pairing and Setup
Pairing
- Remove the battery tab from the Remote before proceeding. When the Glasses are on, press and hold the “+” or “-” volume button on the frame until blue LED blinks. Then, press side button and hold for 8 seconds.

Factory Reset
- Press top button and side button. Hold both for 8 seconds.

Remote Plus user interface
Frame Pairing and Setup
Enter setup mode
- Press and hold both (+) and (-) for 2 seconds.

OK
- Press top button

Exit setup
- Press side button and hold for 2 seconds.

Frame Setup
Next language
- Press (+)

Previous language
- Press (-)

Hearing
Volume up
- Press (+)

Volume down
- Press (-)

- Switch audio mode Press top button

Cycle preset up
- Press the side button and hold for 1 second.

Call
Answer call
- Press top button

End call
- Press top button

Troubleshooting
- Factory reset: If you need to reset the Remote Plus, press the top button and side button together, and hold both for 8 seconds.
- Re-enter/leave setup: If you enter setup unintentionally or need to return to setup screens, use the frame controls to press and hold (+) and (−) for 2 seconds to enter setup mode, and press and hold the side button for 2 seconds to exit setup.
- Setup completion: If setup does not finish, continue until enough data has been collected (the manual states setup completes once sufficient data is collected).
Need more support
Watch the Remote Plus Onboarding video
- For the most up-to-date Instructions for Use please follow this link
- View instructions for use
Documents / Resources
![]() | Remote Plus setup |
References
- Manual Guide | Nuance Audiowww.nuanceaudio.com
- User Manualmanual.tools
Published: November 7, 2026
Updated: November 8, 2026

