nous E3 Zigbee Smart Door and Window Sensor Instruction Manual
You will need Nous Smart Home App. Scan the QR code or download it from direct link
Know about the Contact Sensor
Button
Reset or enter configuration mode: Press and hold the button for 5 seconds until the blue LED blinks, the device will enter configuration mode
Reset or enter configuration mode: Press and hold the button for 5 seconds until the blue LED blinks, the device will enter configuration mode
LED
Blinking: The device enters Zigbee network configuration mode(preparing to connect the gateway)
OFF: The device is under standby status
Blinking: The device enters Zigbee network configuration mode(preparing to connect the gateway)
OFF: The device is under standby status
Quick Installation Guide
Note: Please make sure the gateway is added and on-line before the next step
Note: Please make sure the gateway is added and on-line before the next step
- (If you have installed the NOUS Smart Home on your mobile phone,please go to step 2) Scan QR code or search NOUS Smart Home in APP Store or Google Play to install APP(new user must register account first).
- Open NOUS Smart Home app, on smart gateway homepage, Click: Zigbee Smart Gateway
- Remove the insulation sheet and press the reset button for 5 seconds, till the blue LED blink, then click “LED already blink” on the app.
- Waiting for a few seconds, you can see the this device is shown and you may rename it.
- Put it where you need it.
The alignment marks must be close together as possible.
Must be<15mm
Contents
hide
Documents / Resources
 |
nous E3 Zigbee Smart Door and Window Sensor [pdf] Instruction Manual E3, E3 Zigbee Smart Door and Window Sensor, Zigbee Smart Door and Window Sensor, Smart Door and Window Sensor, Door and Window Sensor, Window Sensor, Sensor |
 |
Nous E3 ZigBee Smart Door and Window Sensor [pdf] Instruction Manual E3 ZigBee Smart Door and Window Sensor, E3, ZigBee Smart Door and Window Sensor, Door and Window Sensor, Window Sensor |