G-010G-D Optical Network Terminal
“
Product Information
Specifications:
- Height: 30 mm (1.2 in)
- Width: 100 mm (3.93 in)
- Depth: 100 mm (3.93 in)
- Weight: 0.407 lb (185 g)
- Power consumption:
- Standby mode: 3.1W
- Typical mode: 4.2W
Product Usage Instructions:
Safety Guidelines:
Warning – Risk of electric shock or fire:
- Connect the Product power adaptor or cord to the right supply
voltage. - The socket-outlet shall be easily accessible.
- Pay attention to the power load of the electrical outlet and
possible extension cord. - Do not connect the plug into an extension cord, receptacle, or
other outlet unless the plug can be fully inserted. - Leave adequate space for heat dissipation to avoid any damage
caused by overheating the Product. - Use the power adapter provided with your Product and ensure the
cable can move freely. - Do not use the Product outside and make sure all connections
are indoors. - Do not install, use, or service this Product during a
thunderstorm.
Caution – Potential equipment damage:
- Keep your product and accessories out of reach of pets.
- If the Product malfunctions or fails to perform as expected,
stop using it immediately. - The product is expected to operate at a temperature of -5 to 45
degrees Celsius for a relative humidity between 5% and 95%.
Install the ONT:
Follow the installation instructions provided in the user manual
to set up the ONT device correctly.
Description of LEDs:
Refer to the table below for the LED indicators and their
corresponding colors and behaviors:
| LED indicator | LED color and behavior |
|---|---|
| Power | Green solid (Power) / Off |
| Alarm | Red flashing fast / Red flashing slow / Off |
| PON | Green solid / Green flashing / Off |
| LAN | Green solid / Green flashing / Off |
LED behavior description:
- Operating on AC power
- Power off
- Software upgrade in progress
- Software upgrade failed; LOS/LOF
- Optical power normal
- ONT ranged and authenticated
- ONT ranging and synchronizing, not yet authenticated
- Fiber not connected or link failure (LOS/LOF)
- Ethernet link is established / Ethernet link is established and
data activity / Ethernet link down or ONT not ready for Ethernet
service
FAQ:
Q: What should I do if the LED indicators show abnormal
behavior?
A: If you notice any abnormal LED behavior, refer to the user
manual for troubleshooting steps or contact your Internet Services
Provider for assistance.
“`
Nokia ONT G-010G-D Quick Reference Guide
1. Product Overview
The Nokia Optical Network Terminal (ONT) G-010G-D is the solution for home networking delivered by Gigabit Passive Optical Network (GPON). It is designed to connect individual users to the network for ultra-broadband services with gigabit speed. The ONT provides a GPON interface to the subscriber and paves the way to deliver premium triple-play services in a fiber to the home (FTTH) environment. It is a temperature non-hardened bridge ONT suitable for indoor use. Compliant with the standard ONT Management Control Interface (OMCI) definition, the G-010G-D ONT can be managed using an AMS and can support the full range of fault, configuration, accounting, performance, and security (FCAPS) functions.
A. Technical Specifications
Height: 30 mm (1.2 in) Width: 100 mm (3.93 in) Depth: 100 mm (3.93 in) Weight: 0.407 lb (185 g) Desk mount or wall mount Power consumption:
Standby mode: 3.1W Typical mode: 4.2W
Figure 1: Nokia ONT G-010G-D
B. Manufacturer Information
For Products Purchased in EU/EAA Countries The products are manufactured and imported by Nokia Solutions and Networks Oy. Karakaari 7, 02160 Espoo, Finland. Nokia is a registered trademark of Nokia Corporation. For Products Purchased in the United States The products are imported by Nokia of America Corporation. · Offices: https://www.nokia.com/contact-us/worldwide-offices/north-america · Support: https://www.nokia.com/support/ · Other contacts: https://www.nokia.com/contact-us/
Please contact your Internet Services Provider in case of questions on the product.
© 2025 Nokia. Nokia Confidential Information. Use subject to agreed restrictions on disclosure and use. If you have received this document in error, do not use or copy this document for any purpose nor disclose its contents to any other person.
CID214318
3TN-01036-AAAA-TCZZB Issue 2, July 2025
Nokia ONT G-010G-D Quick Reference Guide
2. Safety Guidelines
ALWAYS READ THE PRODUCT GUIDE BEFORE SET UP OR USE OF THE PRODUCT. IT IS YOUR RESPONSIBILITY TO FAMILIARIZE YOURSELF WITH THE PRODUCT GUIDE AND WARNINGS, AND TO USE A PRODUCT PROPERLY. CONTACT YOUR INTERNET SERVICES PROVIDER FOR FURTHER QUESTIONS.
Warning – Risk of electric shock or fire
Connect the Product power adaptor or cord to the right supply voltage (for example, 230V in Europe, Australia, South Africa and 120V in US).
The socket-outlet shall be easily accessible.
Pay attention to the power load of the electrical outlet and possible extension cord. An overburdened power outlet or damaged cords and plugs may cause electric shock or fire. Check the power cords regularly. If you find any damage, replace the cord immediately.
Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully inserted with no part of the blades exposed.
Leave adequate space for heat dissipation to avoid any damage caused by overheating the Product. Do not cover the Product or its ventilation holes. Blocking the ventilation holes may cause fire.
Use the power adapter provided with your Product and do not fasten the power cable to building surfaces. Ensure the cable can move freely. Do not place heavy objects on the cable.
Do not use the Product outside, and make sure all the connections are indoors.
Do not install, use, or service this Product during a thunderstorm. There is a remote risk of electric shock from lightning.
Caution – Potential equipment damage
Follow these recommendations to protect yourself and the Product from harm:
· Do not look directly at the optical port without protection. · Do not insert any sharp object into the openings of a Product. · Do not put the Product near a heat source. Avoid placing the Product in direct sunlight. · Do not put the Product in damp or wet locations; for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement, or
near a swimming pool. Do not spill any liquid on the Product. · Do not touch the Product or its power adapter or cord with wet hands. · Do not place the Product on an unstable surface or support. · Do not place heavy objects on top of the Products. · Do not use liquid or aerosol cleaners; unplug the Product and use a soft, dry cloth for cleaning. · When connecting a PC or other electronic device to a Product, make sure you use the right cables and connect the device to the right port
of the Product. Incorrect connections may damage the device and/or the Product. · Do not open or try to open the Product. Opening or removing covers can expose you to dangerous high voltage points or other risks.
It is recommended that users and other individuals maintain a distance of at least 10 cm between themselves and the Product to avoid exposure. The Product contains components that emit an electromagnetic field and could interfere with pacemakers or other electronic medical devices. If you have a pacemaker or other implantable or personal medical device, please consult your physician or medical device manufacturer about the required minimum safe distance between the Product and your medical device.
Keep your product and accessories out of reach of pets. They could damage it and cause injury or electrocution.
If the Product malfunctions or fails to perform as expected, stop using it immediately.
The product is expected to operate at a temperature of -5 to 45 degrees Celsius for a relative humidity between 5% and 95%.
3. Install the ONT
The ONT is normally installed by a professional installer. 1. Plug the power cable to the ONT into power input jack. 2. Plug the power socket to the wall socket. 3. Remove the protective cap on the optical port of the ONT. 4. Remove the protective cap from the optical fiber. 5. Plug the optical fiber to the optical port of the ONT. 6. Connect the ONT to the home router via an Ethernet cable into the Ethernet port. 7. Push the power button to be “ON”. (“ON” = recessed stated, “OFF” = non-recessed state)
© 2025 Nokia. Nokia Confidential Information. Use subject to agreed restrictions on disclosure and use. If you have received this document in error, do not use or copy this document for any purpose nor disclose its contents to any other person.
CID214318
3TN-01036-AAAA-TCZZB Issue 2, July 2025
Nokia ONT G-010G-D Quick Reference Guide
4. Description of LEDs
The following table describes the LEDs of the device:
LED indicator LED color and behavior
Power
Green solid
Power
Off
Alarm
Red flashing fast
Alarm
Red flashing slow
Alarm
Off
PON
Green solid
PON
Green flashing
PON
Off
LAN
Green solid
LAN
Green flashing
LAN
Off
LED behavior description Operating on AC power Power off Software upgrade in progress Software upgrade failed; LOS/LOF Optical power normal ONT ranged and authenticated ONT ranging and synchronizing, not yet authenticated Fiber not connected or link failure (LOS/LOF) Ethernet link is established Ethernet link is established and data activity Ethernet link down or ONT not ready for Ethernet service
5. EU Declaration of Conformity
Hereby, Nokia Solutions and Networks Oy declares that the Product is in compliance with Low Voltage Directive 2014/35/EU, EMC Directive 2014/30/EU, Directive RoHS 2011/65/EU and 2015/863/EU, Directive Eco-design 2009/125/EC and European Accessibility Act Directive 2019/882/EU. The full text of the EU Declaration of Conformity, as well as additional compliance information, is available at www.nokia.com/notices/declaration-of-conformity/.
Products are for indoor use only.
Specific precautions for EMC Warning
The Products are compliant with Class B of EN 55032. In a residential environment, this equipment may cause radio interference. The Products are tested to the requirements of EN 55032 (Emissions) and EN 55024 (immunity). There are no specific precautions which must be taken in order to comply with the requirements of Directive 2014/30/EU Essential Requirements in Section 1 of Annex I. In addition, the Products are further tested to ensure spurious emissions are within the specified limits, as well as meeting the requirements for adaptivity, which mitigates problems caused by co-location with other wireless products. The Products are not subject to the requirements in Section 2 of Annex I of Directive 2014/30/EU for fixed installations.
End of Life Collection and Treatment
In the European Union and European Economic Area, this label indicates that this product should not be disposed of with household waste. It should be deposited in an appropriate facility to enable recovery and recycling.
The Product is marked with this symbol, which is known as the WEEE mark. WEEE stands for Waste Electronics and Electrical Equipment. Electronic products bearing or referencing the WEEE mark shown above, when put on the market within the European Union (EU) and European Economic Area (EEA), shall be collected and treated at the end of their useful life, in compliance with applicable EU and local legislation. They shall not be disposed of as part of unsorted municipal waste. Due to materials that may be contained in the Product, such as heavy metals or batteries, the environment and human health may be negatively impacted as a result of inappropriate disposal.
© 2025 Nokia. Nokia Confidential Information. Use subject to agreed restrictions on disclosure and use. If you have received this document in error, do not use or copy this document for any purpose nor disclose its contents to any other person.
CID214318
3TN-01036-AAAA-TCZZB Issue 2, July 2025
Nokia ONT G-010G-D Quick Reference Guide
At the end of their life, the Products are subject to the applicable local legislations that implement the European Directive 2012/19EU on WEEE. There can be different requirements for collection and treatment in different member states of the European Union. In compliance with legal requirements and contractual agreements, where applicable, Nokia will offer to provide for the collection and treatment of Products bearing the logo above at the end of their useful life, or Products displaced by Nokia equipment offers. The equipment can be disposed at electronic waste collection points or to stores that sell electronics.
For information regarding take-back of equipment by Nokia, or for more information regarding the requirements for recycling/disposal of the Product, contact your service provider. Regulatory compliance information, including EU Declaration of Conformity, can be found at www.nokia.com/notices/declaration-of-conformity/.
© 2025 Nokia Solutions and Networks Oy Nokia is a registered trademark of Nokia Corporation
© 2025 Nokia. Nokia Confidential Information. Use subject to agreed restrictions on disclosure and use. If you have received this document in error, do not use or copy this document for any purpose nor disclose its contents to any other person.
CID214318
3TN-01036-AAAA-TCZZB Issue 2, July 2025
Documents / Resources
 |
NOKIA G-010G-D Optical Network Terminal [pdf] User Guide G-010G-D Optical Network Terminal, G-010G-D, Optical Network Terminal, Network Terminal, Terminal |