Invoering
Welcome to your APC Back-UPS Pro 1500VA 230V Power Saving Uninterruptible Power Supply. This manual provides essential information for the safe and efficient operation of your UPS, designed to protect your electronic equipment from power outages, surges, and fluctuations. Please read this manual thoroughly before installation and use.
Veiligheidsmaatregelen
- Gevaar voor elektrische schokken: Deze UPS bevat gevaarlijke vloeistoffen.tages. Probeer het apparaat niet te demonteren. Onderhoud mag alleen worden uitgevoerd door gekwalificeerd personeel.
- Correcte aarding: Always connect the UPS to a grounded outlet. Do not remove the grounding prong from the power cord.
- Alleen voor gebruik binnenshuis: This product is intended for indoor use only. Do not install the UPS in direct sunlight, near heat sources, or in areas with excessive moisture.
- Ventilatie: Zorg voor voldoende luchtcirculatie rondom de UPS. Blokkeer de ventilatieopeningen niet.
- Batterijveiligheid: Batteries can present a risk of electrical shock and high short-circuit current. Observe all precautions when replacing batteries. Use only APC-approved replacement batteries (RBC154).
- Overbelastingsbeveiliging: Overbelast de UPS niet. Zorg ervoor dat het totale stroomverbruik van de aangesloten apparatuur de capaciteit van de UPS niet overschrijdt.
Inhoud van het pakket
Controleer of alle hieronder vermelde artikelen in uw pakket zitten:
- APC Back-UPS Pro 1500VA 230V UPS Unit
- Gebruikershandleiding (dit document)
- Stroomkabel
- USB-communicatiekabel
Product voorbijview
The APC Back-UPS Pro 1500VA 230V is a tower form factor UPS providing reliable battery backup and surge protection for your critical electronic equipment.
Kenmerken van het voorpaneel

Voorkant view of the APC Back-UPS Pro 1500VA unit, showing the LCD display and control buttons.
- LCD-scherm: Provides real-time status information including input/output voltage, load level, battery charge, and estimated runtime.
- Aan/uit-knop: Turns the UPS unit on or off.
- Weergaveknop: Cycles through various display screens to show different operational parameters.
- Mute/Setup Button: Mutes audible alarms or enters setup mode for configuration.
- USB-A and USB-C Charging Ports: Conveniently located for charging mobile devices.
Kenmerken van het achterpaneel

Achterkant view of the APC Back-UPS Pro 1500VA unit, showing the power outlets, data ports, and main power input.
- Batterijback-up en stopcontacten met overspanningsbeveiliging: Voorzie de stroom van de batterij tijdens gebruik van de batterij.tages and protect against surges. Connect critical equipment here.
- Alleen piekuitgangen: Provide surge protection only. Connect non-critical equipment here.
- Hoofdvoedingingang: Sluit de UPS aan op het stopcontact.
- Zekering: Provides overload protection for the UPS. Press to reset if tripped.
- USB-communicatiepoort: Hiermee wordt de UPS aangesloten op een computer voor energiebeheersoftware.
- Ethernet/Network Protection Ports: Protects network connections from surges.
Instellen
- Uitpakken en inspecteren: Carefully unpack the UPS and all accessories. Inspect for any shipping damage.
- Interne batterij aansluiten: The UPS battery may be disconnected for shipping. Refer to the battery compartment access panel (usually at the bottom or rear) and connect the battery terminals as indicated.
- Plaats de UPS: Place the UPS in a location with adequate ventilation, away from direct sunlight, excessive heat, or moisture. Ensure the front and rear vents are unobstructed.
- Aansluiten op stopcontact: Plug the UPS power cord directly into a grounded 230V wall outlet. Avoid using extension cords or surge protectors with the UPS input.
- Initiële kosten: Allow the UPS to charge for at least 24 hours before connecting any equipment to ensure maximum battery runtime. The battery indicator on the LCD will show charging status.
- Apparatuur aansluiten:
- Sluit essentiële apparatuur (bijv. computer, monitor, router) aan op de Batterijback-up en overspanningsbeveiliging stopcontacten.
- Sluit niet-essentiële apparatuur (bijv. printer, scanner) aan op de Alleen piek stopcontacten.
- Datakabels aansluiten (optioneel): Connect your USB communication cable from the UPS to your computer to enable power management software features. Connect network cables to the Ethernet protection ports if desired.
Gebruiksaanwijzing
Aan/uitzetten
- Aanzetten: Press and hold the Power button on the front panel until you hear a beep and the LCD display illuminates.
- Uitschakelen: Press and hold the Power button until the LCD display turns off.
Navigatie op LCD-scherm
- Press the Display button repeatedly to cycle through various information screens, including: Input Voltage, Uitgangsvolumetage, Load in Watts, Load in VA, Battery Charge Percentage, and Estimated Runtime.
Alarmbeheer
- Tijdens een stroomstoringtage, the UPS will emit an audible alarm. Press the Mute/Setup button briefly to temporarily silence the alarm.
- To permanently disable or enable alarms, refer to the detailed instructions in the full user manual or power management software.
Onderhoud
Batterij vervangen
- The typical battery life is 3-5 years, depending on usage and environmental conditions.
- When the battery needs replacement, the UPS will indicate this on the LCD display and may emit an alarm.
- Use only genuine APC replacement battery cartridges (RBC154) to ensure optimal performance and safety. Refer to the full user manual for detailed battery replacement instructions.
Schoonmaak
- Regularly clean the exterior of the UPS with a dry cloth.
- Zorg ervoor dat de ventilatieopeningen vrij zijn van stof en vuil om oververhitting te voorkomen.
Opslag
- If storing the UPS for an extended period, ensure the battery is fully charged.
- Store the unit in a cool, dry location with adequate ventilation.
- Recharge the battery every 3-6 months to prevent permanent damage.
Probleemoplossing
Hieronder vindt u veelvoorkomende problemen en mogelijke oplossingen:
| Probleem | Mogelijke oorzaak | Oplossing |
|---|---|---|
| UPS gaat niet aan | Battery disconnected or low charge; UPS not plugged in. | Ensure battery is connected. Plug UPS into a live wall outlet and allow to charge. |
| Korte batterijduur | Overloaded; battery old or not fully charged. | Reduce connected load. Allow battery to charge for 24 hours. Replace battery if old. |
| UPS emits continuous alarm | On battery mode; overload; battery fault. | Check power source. Reduce load. Check battery status on LCD. |
| Geen stroom op stopcontacten | UPS off; circuit breaker tripped; battery fault. | Turn UPS on. Reset circuit breaker. Check battery status. |
Technische specificaties
| Functie | Specificatie |
|---|---|
| Modelnummer | BR1500GI |
| Productafmetingen | 4.41 x 15.04 x 11.89 inch |
| Artikelgewicht | 27.9 pond |
| Deeltage | 230 Volt |
| Batterijen | 1 12V-batterijen vereist (meegeleverd) |
| Samenstelling van batterijcellen | Loodzuur |
| Kleur | Zwart |
| Materiaal | Metaal |
| Vormfactor | Toren |
Garantie en ondersteuning
For detailed warranty information, product registration, and technical support, please visit the official APC by Schneider Electric webwebsite of neem contact op met hun klantenservice. Bewaar uw aankoopbewijs als aankoopbewijs voor eventuele garantieclaims.
Aanvullende informatie en contactgegevens vindt u op de volgende pagina: APC by Schneider Electric te koop op Amazon.





