nimly 231024 Connect Module Installation Guide

nimly 231024 Connect Module

Contents hide

Before You Start

You need a compatible nimly device to use this module.
The module communicates wirelessly (Zigbee 3.0) with our Connect Gateway/Bridge (sold seperatly) or connect to other smart home system with support (Athom Homey, Futurehome, Homely and others).

Do you want to create and share digital keys? No gateway required.
Connect with the unloc-app (BLE). Please visit unloc.app for instructions on how to connect.
Bluetooth is only available on the newer versions of the module.

Find your favorite app

Download our nimly connect app (requires gateway/bridge) or use your preferred smart home app with support. If needed, read more about supported smart home systems and requirements on our website https://nimly.io/

Follow the pairing instructions provided in each app.


bluetooth app iOS & Android	nimly connect iOS & Android

Prepare your inside unit for the
installation. On most models, there are two (large) screws in the battery holder and one on the underside.
If you are unsure how to do this, refer to the installation instructions for your specific model.
Carefully install the module in its slot on the inside unit. The bafferies should be removed during installation.
After installing the module, insert all bafferies and verify that the cable between the inside and outside unit is connected.

The module enters pairing mode automatically for four minutes, indicated by orange (zigbee) and blue (bluetooth) flashing from the module.
Did you use too long to connect?
To re-enter pairing mode, remove and reinsert the bafferies/power while the units are connected.

How to reset: hold down the reset button on the module until the orange indicator blinks rapidly (about 15 seconds). Release the button immediately.
On certain modules, you may need to wait four minutes (until pairing mode have ended) before performing the reset.