niko M41HC Motion Detector LOGO

niko M41HC Motion Detector

niko M41HC Motion Detector PRODUCTMotion detector M41HC, 230 V, secondary, high ceiling, 18-53 m, 360°, for surface mounting
Wiringniko M41HC Motion Detector 01

  •  remove if you want to use the contact as a dry contact (potential-free)

Dimensions
Dimensions niko M41HC Motion Detector 02

Installation

Installation niko M41HC Motion Detector 03
niko M41HC Motion Detector 03
niko M41HC Motion Detector 03
niko M41HC Motion Detector 03
niko M41HC Motion Detector 07
niko M41HC Motion Detector 08
niko M41HC Motion Detector 09
niko M41HC Motion Detector LOGO

  • If a grommet needs to be replaced, please make sure the new grommet is halogen-free

Dismantling
niko M41HC Motion Detector 11
niko M41HC Motion Detector 12
App settingsniko M41HC Motion Detector 21

LED behavior

Green LED continuous on niko M41HC Motion Detector 13 Connection OK
Green LED flashing niko M41HC Motion Detector 13 Warming up Wait
Red LED continuous on niko M41HC Motion Detector 15 Error niko M41HC Motion Detector 17More info –>
detector tool
Blue LED flashing niko M41HC Motion Detector 15 Walk test active

Specifications

niko M41HC Motion Detector 22

Detection area

niko M41HC Motion Detector 18
niko M41HC Motion Detector 19

  •  not specified Measured according to EN/IEC63180

Troubleshooting

niko M41HC Motion Detector 19Support & contact
Industriepark West 40 9100 Sint-Niklaas, Belgium www.niko.eu

+32 3 778 90 80 support@niko.eu

Niko prepares its manuals with the greatest care and strives to make them as complete, correct and up to date as possible. Nevertheless, some deficiencies may subsist. Niko cannot be held responsible for this, other than within the legal limits. Please inform us of any deficiencies in the manuals by contacting Niko customer services at support@niko.eu.

Documents / Resources

niko M41HC Motion Detector [pdf] Instruction Manual
M41HC, Motion Detector, M41HC Motion Detector

References

Leave a comment

Your email address will not be published. Required fields are marked *