NICREW 08606 HyperReef Mount System
Warning
- Please read and adhere to the instructions provided. Failure to do so may cause damage to the HyperReef Mount System, breakage of the light, or harm to your tank, livestock, and surrounding areas.
- Any damage incurred from failing to read or follow these instructions will not be covered under warranty. NICREW cannot be held responsible for any damages that result from non-compliance with the instructions.
Limited Warranty
NICREW products carry a 12-month limited warranty from the date of purchase. This warranty is non-transferable and valid for the original purchaser only. If your product is within warranty and you require a replacement part or service, please contact us at support@nicrew.com.
For more information, please visit www.nicrew.com.
Overview
HyperReef 200 X-bracket is illustrated above, HyperReef 100/150 X-bracket is installed identically.
Spare Parts & Tools Included
Spare Parts & Tools Included:
Assembly Instructions
Step 1
Choose an appropriate Edge Clamp combination for your setup.
NOTE:
For Combo 4 and 5, the light height is fixed at approximately 12″ above the water surface.
Step 2
Insert the Formed Arm into the Edge Clamp, then tighten the screws to fix it at the desired height.
Step 3
Slide the X-Bracket onto the Sliding Rail, align the hole with the Slide-in economy T-nut, then tighten down the screw.
Step 4
Mount HyperReef to the X-Bracket using the provided corner screws with a screwdriver (not included).
Step 5
Guide the Sliding Rail onto the Formed Arm, and tighten the screw to lock it in desired position.
Step 6
Secure the HyperReef Mount System to the aquarium by tightening the screws.
WARNING:
Do not overtighten screws, it may cause damage to the aquarium or Edge Clamp.
Step 7
Route the power cord through the hole in the Formed Arm.
Watch the Mount Installation Video
Documents / Resources
 |
NICREW 08606 HyperReef Mount System [pdf] Instruction Manual 08606 HyperReef Mount System, 08606, HyperReef Mount System, Mount System, System |