User Manual
Bluetooth Remote Control
Suitable for Smartphones
Identifying the parts
- LEO Power Indicator
- Power ON/OFF
- Mode Switching
- Lens Switching
Button - Lens Zoom Button
- Shutter and video button
Specifications
Model:MP02
Name: Detachable Bluetooth Selfie Stick
Wireless Type: Bluetooth 5.0
Receiving Distance: 15 m
Battery Capacity: 3. 7V 60mAh
TYPE-C Charging: 5V
Material: Plastic
Dimensions: 47.32510mm
Weight: about 9g
Functions: Take photos, recording video, zoom, lens switching and other functions
Features
■ It can remotely control the mobile phone shooting, video recording, zoom, lens switching and other functions.
Rechargeable Bluetooth remote control for convenient charging and recycling.
Lens zoom Button
Lens can zoom
shutter and video button
Press to start shutter taking photos and video recording,press again to end the shutter or recording
Power ONIOFF I Mode switching
Power On/Off Button: Long press for three seconds to turn the power on or off.
Mode Switching Button: Switch
between Zoom in Photo mode or
Zoom in Video mode.
Lens Switching Button
to switch front-facing lens or rear-facing lens
When pairing, the phone can search for Bluetooth name “MP02”
LED Indicator Instruction
- After turning on, the blue light flashes. After connecting and pairing, the blue light stays on for a long time.
- Not connected or not operating when connected to the phone, the Bluetooth remote control will automatically shut down after five minutes.
Charging light indication:
The RED light stays on when charging, and the GREEN light stays on when fully charged
Bluetooth Connection
Open Bluetooth settings on your phone, search and connect the Bluetooth device name “MP02” After connected and paired successfully, the blue light stays on.
FCC Caution ：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that maycause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Warranty
Newmowa provides customers with warranty of 12 MONTHS from the date of purchase.
Find us on amazon:
Newmowa
:service@newmowa.com
:www.facebook.com/newmowa
:www.newmowa.com
Documents / Resources
 |
Newmowa MP02 Bluetooth Remote Control [pdf] User Manual MP02 Bluetooth Remote Control, MP02, Bluetooth Remote Control, Remote Control |