RS100 Wi-Fi 7 Router
“
Product Information
Specifications:
- Compliance: Part 15 of the FCC Rules
- Operation Conditions: Not to cause harmful interference, must
accept any received interference - Installation: Maintain a minimum distance of 20cm between the
radiator and user’s body - Regulations: Indoor use only for UNII-4 Indoor AP
Product Usage Instructions
FCC Interference Statement:
- Reorient or relocate the receiving antenna if interference is
experienced. - Increase the separation between the equipment and
receiver. - Connect the equipment to an outlet on a different circuit from
the receiver. - Consult a dealer or experienced technician for assistance.
Mobile Device Usage (Radiation Exposure):
This equipment should be operated with a minimum distance of
20cm between the radiator and the user’s body.
Country Code Selection Usage (WLAN Devices):
Country code selection is for non-US models only. US models must
operate on US channels per FCC regulations.
UNII-4 Indoor AP:
This device is restricted to indoor use only as per FCC
regulations.
FAQ
Q: Can I use this device outdoors?
A: No, this device is designed for indoor use only as stated by
FCC regulations.
Q: What should I do if I experience interference?
A: Try reorienting or relocating the receiving antenna,
increasing separation between devices, or consult a professional
for assistance.
“`
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
– Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FOR MOBILE DEVICE USAGE (>20cm/low power eg. AP routers) Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES) Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
For UNII-4 Indoor AP
FCC regulations restrict the operation of this device to indoor use only.
Documents / Resources
 |
NETGEAR RS100 Wi-Fi 7 Router [pdf] Instructions 24300638, PY324300638, RS100 Wi-Fi 7 Router, RS100, Wi-Fi 7 Router, Router |