myFirstech DL-CH12 Jeep Compass PTS Instruction Manual

Contents hide

myFirstech DL-CH12 Jeep Compass PTS

FIRMWARE:
This installation requires BLADE-AL(DL)-CH12, flash module, and update the controller firmware before installing.

INSTALLATION:
Type 3A vehicles use CAN connections in harness at OBD-II connector, the included CAN extension cable is not required for this install type.

IGNITION:
Type 3 ignition is available at the power steering module connector (black, 10-pin connector, pin #1, orange/white), located under the steering wheel.

RAP:
Retained accessory power is handled by harness provision (orange/white), and is connected to the driver door pin circuit at the BCM (connector C6, pin #7, white purple).

FTI-CDP1 – Installation and Configuration Notes

REQUIRED CONNECTION (OBD-II CAN)
NOT REQUIRED (CAN extension)

NO CONNECTION
REQUIRED CONNECTION (IGN)

REQUIRED CONNECTION (DDP RAP)

FTI-CDP1 – DL-CH12 – Type 3A 2017-18 Jeep Compass PTS

LED Programming Error Codes

Module LED flashing RED during programming
1x – CAN Error

2x – Key code not learned
3x – No IGNITION

4x – No immobilizer, check CAN/key
5x – VIN error, check CAN wiring

6x – See 4x error
7x – KLON error

8x – No IGNITION, check connection

INSTALL GUIDE

MODULE PROGRAMMING PROCEDURE – PTS

IMPORTANT: The hood must be closed.

Close the driver’s door. Re-open the driver door to wake up the data bus.

Press UNLOCK on the OEM remote. (If the vehicle is not equipped with an OEM remote, press the module programming button.)
Wait, LED will fl ash BLUE once [1x]. If the LED does not fl ash GREEN, repeat step 2.

Set ignition to ON position
Wait, if LED turns solid RED proceed to step 6. If LED ﬂ ashes BLUE rapidly, proceed to step 10.
Set ignition to OFF position.
Repeat steps 4 to 6, eight times [8x].
Set ignition to ON position.
Wait, the LED will ﬂ ash BLUE rapidly.
Set ignition to OFF position.
WARNING: Disconnect power last. Disconnect the module from the vehicle.
Connect the module to the computer and proceed with extended programming.
WARNING: Do not press the module programming button. Connect power ﬁ rst. Connect module to vehicle.
Set ignition to ON position.
Wait, the LED will turn solid BLUE for 2 seconds.
Set ignition to OFF position.
Module Programming Procedure completed.

IMPORTANT
All vehicle doors must be closed and locked before the remote start sequence. Failure to comply will result in a remote starter malfunction.

TAKE OVER PROCEDURE – PTS – TO THE VEHICLE OWNER

NOTE All vehicle doors must be closed and locked before rethe mote start sequence.

TIME RESTRICTI N COMING UP !

Unlock the vehicle door using an OEM or after-market remote, or door request switch.
TIME RESTRICTI NWithin 45 SECONDS from the previous step: Open vehicle door. Enter vehicle. Close the vehicle door. Press and release the BRAKE pedal.