muRata NCP03 NTC Temperature Sensor Instruction Manual

Minimum Quantity Guide

Tape Carrier Packaging

1. Dimensions of Reel
   
2. Taping Method
   1. A tape in a reel contains Leader unit and Trailer unit where products are not packed. (Please refer to the figure at the right.)
   2. The top and base tapes or plastic and cover tape are not stuck at the first five pitches minimum.
   3. A label should be attached on the reel. (MURATA’s part number, inspection number and quantity should be marked on the label.)
   4. Taping reels are packed in a package.
      Continued on the following page.
      Taping Dimensions
      
3. Paper Tape (NCP03/15/18 Series, NCU15/18 Series)
   NCP03 Series
   
   Direction of Feed
   NCP15, NCU15 Series
   
   Direction of Feed
   * Reference Value
   NCP18, NCU18 Series
   
   Direction of Feed
   * Reference Value
   1. Other Conditions
      (a) Packaging
      Products are packaged in the cavity of the base tape and sealed by a top tape and bottom tape.
      (b) Tape
      The top tape and bottom tape have no joints and products are packaged and sealed in the cavity of the base tape, continuously.
   2. Peeling Force of Top Tape
      
      • 1 Peeling angle: 165 to 180° against the fixed surface of tape.
      • 2 Peeling speed: 300mm/min.
      • 3 Peeling force: 0.1 – 0.6N
4. Embossed Tape (NCP21 Series)
   1. Other Conditions
      (a) Packaging
      Products are packaged in the each cavity of Embossed tape and sealed by Cover tape.
      (b) Tape
      Cover tape has no joints.
      
   2. Peeling Force of Cover Tape
      
      • 1 Peeling angle: 165 to 180° against the fixed surface of tape.
      • 2 Peeling speed: 300mm/min.
      • 3 Peeling force: 0.1 – 0.7N

Documents / Resources

muRata NCP03 NTC Temperature Sensor [pdf] Instruction Manual NCP03 NTC Temperature Sensor, NCP03, NTC Temperature Sensor, Temperature Sensor, Sensor

References

• User Manual