MTS MOTION QS-210 Qubic Extension Set
Specifications
- Parts Included: 3x 475, 8x 40, 8x 6, 6x 30, 8x 18, 14x M8, 8x 16
- Dimensions: Various sizes in mm
- No extra or spare parts listed
Assembly
These instructions demonstrate how to attach the switch boxes underneath the MTS RIG. Only the necessary material is included in the scope of delivery. Mounting brackets for the actuators must be obtained from the motion system manufacturer. For further instructions, refer to the Motion System operating instructions.
Note: Base frame bottom view requires installation of three additional profiles.
Installation Steps
- Attach the switch boxes underneath the MTS RIG.
- Ensure all necessary materials are available.
- Order mounting brackets for the actuators from the motion system manufacturer.
- Install three additional profiles on the base frame bottom view.
Additional Components
An additional base plate (marked green) is essential to prevent stepping on the control boxes from above.
Frequently Asked Questions (FAQ)
Q: Do I need to purchase additional parts for assembly?
A: Yes, mounting brackets for the actuators must be ordered separately from the motion system manufacturer.
MTS MOTION
QUBIC EXTENSION SET
Instruction Manual
PARTS
[dimensions in mm / different scales] No extra or spare parts listed!
ASSEMBLY
These instructions only show how to attach the switch boxes underneath the MTS RIG.
Only the necessary material is included in the scope of delivery. The mounting brackets for the actuators must be ordered from the manufacturer of the motion system.
For all further instructions, please read the Motion System operating instructions!
Documents / Resources
 |
MTS MOTION QS-210 Qubic Extension Set [pdf] Instruction Manual QS-210 Qubic Extension Set, QS-210, Qubic Extension Set, Extension Set, Set |
