MPOW T6 TRUE WIRE LESS EAR BUDS MODEL: BH333A
Wireless Earbuds

INCOMING CALL
  1. Answer/Hang up
    Click the MFB button on the Right or Left earphone once.
  2. Reject
    Keep pressing the M FB button on the Right or Left earphone for ls.
  3. SIRI
    Triple-click MFB button on the Right earphones.
PACKING LIST

PACKING LIST

DIAGRAM

DIAGRAM

RESET

RESET

In the state of charging. simultaneously press and hold both MFB buttons for 5s.

PAIRING

PAIRING

Take out the earphones. they automatically enter the pairing mode when the blue and green lights start flashing alternately, and then select”Mpow T6″.
Note: The earbud will reconnect to the paired device by priority. If you want to pair to the second smartphone. please disconnect Bluetooth on the paired smartphone.

CHARGING

CHARGING

Do not put the earbuds in the charging case when the earbuds are wet.

CORRECT DISPOSAL OF THIS PRODUCT

( Waste Electrical& Electronic Equipment )
A This Marking shown on the product or its literature. – indicate that it should not be disposed with other household wastes at the end of its working life.

To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.Household user should contact either the retailer where they purchased this product or their local government office, for details of where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contact This product should not be mixed with other commercial wastes for disposal.

POWER ON

POWER ON

POWER OFF

POWER OFF

FCC STATEMENT
Operation is subject to the following three conditions:
  1. This device may not cause harmful interference. and
  2. This device must accept any interference received. including interference that may cause undesired operation.
  3. This device has been evaluated to meet general RF exposure requirement The device can be used in portable exposure condition without restriction.

NOTE: 
This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

VOLUME +/-

Volume+: press and hold the MFB button of Right earbud to turn up the volume increasingly.
Volume-: press and hold the MFB button of Left earbud to turn down the volume decreasingly.

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Support: https://www.xmpow.com/

MPOW T6 User Manual BH333A – Optimized PDF
MPOW T6 User Manual BH333A – Original PDF

Join the Conversation

2 Comments

  1. I have the mpow t6 and the sounds of the helmets have been lowered and how to raise them I can hardly hear
    Tengo los mpow t6 y se me a bajado los sonidos de los cascos y ns como subir los no se escucha casi

  2. Am having the same issue..no matter how I try to increase the volume its stay low..I can hardly hear..

Leave a comment

Your email address will not be published.