USER MANUAL

True Wireless Earbuds

True Wireless Earbuds
Model: Mpow M30 Plus

PACKING LIST

PACKINC LIST

DIAGRAM

DIACRAM

POWER ON

POWER ON
  1. The earphones automatically turn on(with white LED light flashing) and start pairing when you open the charging case.
  2. In the shutdown status and when the earphones are not in the charging case. simultaneously press and hold the MFB of both earbuds for 2 seconds to power on ( with the white LED light flashing).

POWER OFF

POWER OFF
  1. Put the earphones back in the charging case and close the case to turn them off.
  2. If the earphones are not in the charging case. just press and hold the MFB of both earbuds for 5 seconds to power them off. (Mode 2 cannot be conducted during music playing or calling.)

PAIRING

PAIRING
  1. Open the charging case, they will automatically enter the pairing mode in which the LED light flashes white and red alternately, and then select “Mpow M30 PlusĀ·.

Note: The earbud will reconnect to the paired device by priority. If you want to pair to the second smartphone, please disconnect Bluetooth on the paired smartphone.

MUSIC

MUSIC

INCOMING CALL

INCOMING CALL

MUSIC & INCOMING CALL & Siri

Volume Up/ Down
Volumes +: press and hold the MFB button of Right earbud to tum up the volume increasingly.
Volumes – : press and hold the MFB button of Left earbud to turn down the volume decreasingly.

Next/ Previous Track
Next Track: double tap the MFB of Right earbud.
Previous Track: double tap the M FB of Left earbud.

Play/ Pause
Tap the MFB of either earbud once.

Answer/ Hang Up
Double tap the MFB of either earbud.

Reject
Press and hold the MFB of either earbud for l second.

Activate Siri
Triple-tap the MFB of either earbud.

RESET

RESET

In the state of charging, press and hold the button on the charging case for l O seconds. The LED will flash red, which means that the paired information is cleared successfully.

CHARGING

Charging

Do not put the earbuds in the charging case \A/hen the earbuds are wet

CORRECT DISPOSAL OF THIS PRODUCT

( Waste Electrical& Electronic Equipment)

Waste

This Marking shown on the product or its literature. indicate that it should not be disposed with other household wastes – at the end of its working life.

To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wast.es and recycle it responsibly to promote the sustainable reuse of material resources. Household user should contact either the retailer where they purchased this product. or their local government office, for details of where and how they can take this item for environmentally safe recycling.


Business users should contact their supplier and check the terms and conditions of the purchase contact This product should not be mixed with other commercial wastes for disposal.

FCC STATEMENT

Any Changes or modifications not expressly approved by the party responsible for compliance could void the use(s authority to operate the equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions,

(1) This device may not cause harmful interference. and

(2) this device must. accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment

Questions about your Manual? Post in the comments!

Leave a comment

Your email address will not be published. Required fields are marked *