morel 210MU603A Car Audio Component Speaker System
Content
Woofer and Mid Mounting
Crossover Connection
Active Configuration Guide
The Maximo Ultra MIl 603A is an “active” component speaker set requiring the use of electronic crossover and six channels of amplification. The crossover can be a stand-alone electronic type or integrated in an aftermarket radio, amplifier, or a DSP (digital sound processor). Setting up the Maximo Ultra MI603A system may vary based on the crossover’s features, vehicle cabin acoustics, and the mounting location of the individual speakers. The following guidelines should be used to assure each speaker in the system performs to the highest level while functioning in a safe operating range.
Below is the Recommended Crossover Guide. The guide contains both recommendations for Optimal Crossover Points to be used as a starting point for the crossover settings. Additionally, there is a Recommended Crossover Range for each speaker that you can reference to safely dial in your system. Please note that Morel recom- mends using no less than a 12dB per octave filter on all crossover selections, however a steeper filter slope (18dB or 24dB) may be used as needed.
Recommended Crossover Guide
- Optimal Crossover Points
- Tweeter high-pass filter 4,500Hz @ 12dB
- Midrange low-pass filter 4,500Hz @ 12dB
- Midrange high-pass filter 500Hz @ 12dB
- Woofer low-pass 500Hz @ 12dB
- Recommended Crossover Range
- Tweeter high-pass filter 3,500-6,000Hz @ 12dB
- Midrange low-pass filter 3,500-6,000Hz @ 12dB
- Midrange high-pass filter 300-800Hz @ 12dB
- Woofer low-pass 300-800Hz @ 12dB
Wiring
Mounting
Surface mounting
Flush mounting for 50mm (1.96″) cutout – Option 1
Flush mounting – Option 2
Specifications
Documents / Resources
 |
morel 210MU603A Car Audio Component Speaker System [pdf] User Guide 210MU603A, 210MU603A, 210MU603A Car Audio Component Speaker System, 210MU603A, Car Audio Component Speaker System, Component Speaker System, Speaker System |