MONSTERTECH 0078 Flight Stand 
GENERAL ASSEMBLY INFO AND HOW TO
PROFILE NUT
HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED
UNIVERSAL CONNECTOR
BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]
PROFILE CAP ASSEMBLY
SCOPE OF DELIVERY
PEDAL EXTENSION SCOPE OF DELIVERY
ASSEMBLY
installation
intend to used
OPTIONAL PEDAL EXPANSION ASSEMBLY
Diminssion
WARNING NOTICES
CAUTION!
Do not clamp your fingers while assembling the flight stand.
CAUTION!
Check before usage if all screws are tightened.
CAUTION!
Check before usage that the mounting plates are screwed on tight after making height adjustments.
DANGER:
Contains small parts not suitable for children under 3 years. Only suitable for children over 12 years and adults. All MTSIM products are hand assembled and quality checked. The mount is designed for usage only with a computer controller (e.g. joystick or throttle). We exclude liability if the product is used for purposes other than intended. MTSIM shall be liable for damage arising from causes other than the detriment to life, body and health only to the extent that such damage arises from wilful misconduct, gross negligence or the culpable violation of a fundamental contractual obligation on the part of MTSIM or a vicarious agent (e.g. the delivery service) of MTSIM. Any further liability for damages shall be excluded. If you have safety concerns or questions regarding assembly, contact us under info@mtsim.com or visit www.mtsim.com/en/
Documents / Resources
 |
MONSTERTECH 0078 Flight Stand [pdf] Instruction Manual 0078, Flight Stand, 0078 Flight Stand, Stand |
