ML35 Huben2 Mechanical Controller
Product Information
Specifications
- Model: XYZ-2000
- Dimensions: 10 x 5 x 3 inches
- Weight: 2 pounds
- Power: 120V AC
- Material: Plastic
Product Usage Instructions
1. Setup
Before using the product, ensure that it is placed on a flat and
stable surface near a power outlet.
2. Power On
Plug in the product to a 120V AC power source and switch the
power button to the ‘ON’ position.
3. Operation
Follow the instructions on the display screen to navigate
through the product’s features. Use the buttons on the product to
make selections.
4. Maintenance
Regularly clean the product with a damp cloth and avoid using
harsh chemicals that may damage the plastic material.
FAQs
Q: How do I reset the product?
A: To reset the product, locate the reset button at the back of
the device and press it using a small pin or paperclip.
Q: Can I use the product outdoors?
A: It is recommended to use the product indoors to prevent
exposure to extreme weather conditions that may affect its
performance.
FCC Caution. (1)§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Changes or modification warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. According to §15.247(e)(i) and §1.1307(b)(1), systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy level in excess of the Commission’s guidelines.
Documents / Resources
 |
MOBAPAD ML35 Huben2 Mechanical Controller [pdf] User Manual ML35, ML35 Huben2 Mechanical Controller, Huben2 Mechanical Controller, Mechanical Controller, Controller |