MIYOTA 6P28 Analog Multi Function Quartz Watch Instruction Manual
DISPLAY
NORMAL CROWN POSITION 1ST POSITIONTIME SETTING (CLOCKWISE
OPERATION PROCEDURE
- SETTING THE TIME (HOUR, 24HOUR, MINUTE and SECOND)
SETTING THE TIME (HOUR, 24 HOUR, MINUTE AND SECOND)
The hour, 24 hour, minute and second are set by the same operation.
SETTING PROCEDURE
Pull the crown out to the 1st position to stop the second hand at 0 (12 o’clock). Turn the hour/minute hands in a clockwise direction to set the time. To ensure time is set accurately, first turn the minute hand 5 minutes ahead of desired time and then turn back (in a counterclockwise) to the desired time. After setting the time, use a time signal to synchronize the watch by pushing crown to the normal position to start the second hand going.
NOTE: Make sure you have correctly set AM/PM before setting the time.
These specifications might be changed without prior notice.
Documents / Resources
 |
MIYOTA 6P28 Analog Multi Function Quartz Watch [pdf] Instruction Manual Cal. 6P28, 6P28 Analog Multi Function Quartz Watch, 6P28, Analog Multi Function Quartz Watch, Multi Function Quartz Watch, Quartz Watch, Watch |
