MiTwoo S5 Mini Camera User Manual

MiTwoo S5 Mini Camera

Introduction

This product is a U disk storage, high-definition digital camera, camera motion detection, charging while video, memory support 32GB, connect the computer camera, direct storing function TF card memory, security cameras, photo shoot and high-definition screen, the product has the advantages of simple operation, small and exquisite, beautiful and practical, easy to carry, is home security, education, living in areas such as the necessary practical tools, by the user’s favor.
Notice

• The interior is a precision electronic components, operation can not touch the operation to avoid damage to the key.

Characters of Product

• It has a small contour design. It is very fashionable and wearable, and matches all kinds of portable tools.
• Support PC camera and chatting function.
• Support AVI video format.
• Size: 50mm*25mm*23mm
• Support Video resolution 1920*1080P or 1280*720P, 30 fps
• Support Camera resolution 1920*1080
• Support 128GB T-flash card. (maximum)
• Built-in polymer lithium battery, capacity 200mAh

Operation Guide

Charge
When you use it for the first time, please charge it first. The charging method is as follows:

1. Connect the computer: Use a USB cable to connect the computer, and then it can be charged.
2. Use an adaptor: connect the charger plug with USB cable, then plug it into the electrical outlet connector receptacle, and it can be charged. When you charge it, the red light will brighten simultaneously, finish charging, Red right stops flashing.

Notice

• When battery power is not enough, the device will enter protection mode,

Power On/Off

• Power On: Press and hold the power button for three seconds until the red indicator light turns on.
• Power Off: In the stopped recording state, press and hold the power button for three seconds to power off.

Video Recording

With audio recording

• After inserting the memory card and powering on, the camera will directly enter video recording standby mode.
• The screen will display a recording symbol in the upper left corner.
• Press the power buțton once to start recording.
• During recording, press the power button once to stop recording and return to standby mode.
• Without audio recording: In video recording mode, press the up button once to display a mute symbol in the upper left corner.
• Press the power button again to enter silent video recording mode.

Taking Photos

• In video recording standby mode, press the mode button once to enter flash photography mode.
• The screen will display a camera symbol in the upper left corner.
• Press the power button once to take a photo, and the flash will illuminate.
• Without flash and sound: In flash photography mode, press the up button once to display a mute symbol on the screen, entering silent and flashless photography mode.

Voice Recording

• During standby mode, press and hold the mode button for two seconds to start voice recording.
• Press the power button once to save the recording file and return to voice recording standby mode.
• Press the mode button for two seconds to return to video recording standby mode.

Continuous Flash

• During standby mode, press and hold the up button for two seconds to keep the flash continuously on.
• This can provide extra lighting for photography and recording.

Applying Filters

• During standby mode, press the down button once to switch between five filter modes.

Charging while Recording

• When connected to a charger or power bank, you can manually operate video recording and audio recording. up

Playback Mode

• During standby mode, press the mode button repeatedly to enter playback mode.
• The screen will display the most recently recorded file.
• Use the up and down buttons to switch between files.
• Press the power button to play the selected file, and press the mode button once to return to video recording mode.

Time Display Setting

1. Insert the TF card into the device and connect to the computer after powering on. Open the root directory and find the text document named time.txt.
2. Open the time.txt document and strictly follow the format to write the desired synchronized time (only change the text inside). Save and restart the device to synchronize the time.
   • 2012-05-01 23:59:59 Y (have time in video)
   • 2012-05-01 23:59:59 N (no time in video)

Auto Screen Off

• In standby mode, if there is no operation for 30 seconds, the screen will automatically turn off to save power. Press the power button once to wake up the screen.

Connecting to Computer

• With a memory card: Connect the camera to a computer via USB to read video files and perform file operations such as copying, cutting, and deleting. After connecting, the computer will recognize the camera as a removable disk.
• Without a memory card: Connect the camera to a computer to use it as a computer webcam.

 Reset Button

• There is a reset hole on the side of the USB port. If the device freezes, you can insert a card pin into the reset hole to reset it