MITSUBISHI ELECTRIC SKE45A-04 Smart Keyless System Hand Unit

Specifications

• Smart Keyless functions with Keyless entry system
• Operational range for engine start permission: up to 80 cm (2.6 feet) from the center of the Start Button
• Remote function operating range: up to 3 m (9.8 feet) from the center of the Start Button
• Child Lock mode available for Hand Unit

Smart Keyless functions

The Smart Keyless functions (Keyless entry system) enables the following operations while the Hand Unit is being carried.

• When the operator pushes the Start Button, the system is activated and the engine start propriety (permission / prohibition) is determined.
• The engine start is permitted if the operator is only within operational range while the Hand Unit is being carried.
• The operational range for the engine start permission is up to 80 cm (2.6 feet) from the center of the Start Button in the control panel.

1. Engine start permission
   1. In the case of permission
      The buzzer sounds 3 times, and LED on the control panel turn on.
   2. In the case of prohibition
      The buzzer sounds 4 times, and LED on the control panel turn off after flashing.
2. The System stop
   The System will run out when pushing the Start Button in the engine stop state. The buzzer sounds 1 time, and LED on the control panel turned off.
3. Emergency engine stop
   The engine is stopped by pushing the Start Button (1 second or more) at the engine operating state.
   The buzzer continues to sounding, and LED on the control panel turned off.
   The buzzer is stopped by pushing the Start Button again.

Remote function

1. In the engine stop state, the Remote function can be turned off the system by pushing the button on the Hand Unit. Then, (when the button on the Hand Unit is pushed), the buzzer sounds 1 time, and LED on the control panel turned off.
   The operating range is up to 3 m (9.8 feet) from the center of the Start Button in the control panel.
2. With the system off state, the engine can not be started.

Child Lock mode of the Hand Unit

1. When you continue pushing the button on the Hand Unit (1 second or more), it will be the Child Lock mode.
   When it comes to tte Child Lock mode, LED of the Hand Unit is turned on 0.5 seconds. In the Child Lock mode, the function of the 1 and 2 above can not operate.
2. To cancel the Child Lock mode, you must push the button of the Hand Unit (1 second or more) again.
   When the Child Lock mode is released, LED of the Hand Unit is turned on 0.1 seconds.

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC/ISED
This device complies with part 15 of FCC Rules and Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF energy.

FAQ

• Q: What should I do if the system does not respond to the Hand  Unit?
  A: Check the battery of the Hand Unit and replace it if  necessary. Ensure you are within the specified operating range for  proper functionality.

Documents / Resources

MITSUBISHI ELECTRIC SKE45A-04 Smart Keyless System Hand Unit [pdf] User Manual SKE45A-04, SKE45A-04 Smart Keyless System Hand Unit, Smart Keyless System Hand Unit, Keyless System Hand Unit, Hand Unit

References

• User Manual