MIRO-logo

MIRO W5 AI TWS Device

MIRO-W5-AI-TWS-Device -product

SPECIFICATION

  • Speaker Sensitivity: 95±3dB
  • Working Range: 10m
  • Battery: 55mAh*2
  • Music & Call Time: 5 hours
  • Standby Time: 50 hours
  • Charge Time: 1.5 hours
  • Input: 5V IA

WARNING

This product can expose you to chemicals including Diisononyl Phthalate(DINP) and Di(2-ethylhexyl) Phthalate(DEHP), which are known to the State of California to cause cancer. and Di-isodecyl Phthalate(DIDP) and Di(2-ethylhexyl) Phthalate(DEHP), which are known to the
State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

Manufacturer
Foxx Development Inc.

Brand
MIRO

Address
3480 Preston Ridge Rd Suite 500, Alpharetta, CA 30005

MIRO-W5-AI-TWS-Device - (2)

Device Temples pairing
After power on, two sides glasses temples  paired automatically

Connecting Device

Turn On Wireless, search and select “MIRO W5” from the detected devices

Charging

Magnetic charging: LED indicator in red  light meaning it’s charging. LED indicator light off meaning it’s fully charged. ( It takes 90 minutes to fully charged.)

MIRO-W5-AI-TWS-Device - (3) MIRO-W5-AI-TWS-Device - (1)

WARNING

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
  • Consult the dealer or an experienced radio/TV technician for help.

Important: Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

FCC Warning

Labeling requirements

Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications . However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

FCC RF Radiation Exposure Statement: 

  1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
  2. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 5mm between the radiator and your body.

Documents / Resources

MIRO W5 AI TWS Device [pdf] User Manual
W5, W5 AI TWS Device, AI TWS Device, TWS Device, Device

References

Leave a comment

Your email address will not be published. Required fields are marked *