miniprinter-logo

miniprinter NBS-SL856B Bluetooth Device

miniprinter-NBS-SL856B-Bluetooth-Device-product

Basic instructions

  • Power on: Press button for 3s then it power on.
  • Power off: Scan “power off” barcode or wait it power off automatically.
  • Low power warning: Di-DI-DI-Di beep is low power warning, if not charge, the scanner wil power off.

Battery charging: Two charging ways:

  1. Connect micro USB to scanner
  2. Place the scanner on the Cradle to charge. red light on shows charging normally, until light off, charging finish.

System setting

  • Restore factory settingminiprinter-NBS-SL856B-Bluetooth-Device-fig-1

Connection Setting

Bluetooth keyboard:

  1. scan the barcode.
  2. terminal device search bluetooth device signed with “SerNum”.
  3. connect successfullyminiprinter-NBS-SL856B-Bluetooth-Device-fig-2

Note: This mode is used to transfer keyboard data to the dialog box. Please delete the old device information before connecting the new device

Connect with cradle:
Scan the barcode attached to the cradleminiprinter-NBS-SL856B-Bluetooth-Device-fig-3

Note: Scan this bar code, the Bluetooth device is disconnected from the connected device, and other devices cannot check the existence of this device.

KBD type

  • Windows/Android
  • Mac/iOSminiprinter-NBS-SL856B-Bluetooth-Device-fig-4

Suffix Setting

  • Add CR Suffix
  • Add LF Suffix
  • Add CR+LF Suffixminiprinter-NBS-SL856B-Bluetooth-Device-fig-5

Input method setting

  • Android/lOS/ Switch Input Method
  • Windows/ Switch Input Methodminiprinter-NBS-SL856B-Bluetooth-Device-fig-8

Note: Please set input method to English

  • OS/Popup/Hide Virtual keyboard (IOS)miniprinter-NBS-SL856B-Bluetooth-Device-fig-1

Power setting

  • Power offminiprinter-NBS-SL856B-Bluetooth-Device-fig-1

Transmit mode

Synchronous transmission

miniprinter-NBS-SL856B-Bluetooth-Device-fig-1

  • Note: Data is transmitted during bluetooth connection and lost when disconnected

Asynchronous transmission

miniprinter-NBS-SL856B-Bluetooth-Device-fig-1

Note: Data is transmitted during bluetooth connection, stored when disconnected, and uploaded automatically after reconnection

Transmit mode

  • Batch storage modeminiprinter-NBS-SL856B-Bluetooth-Device-fig-1

Note: Data is always stored.

  • Upload all stored data
  • Count the total number of uploaded data
  • Clear stored dataminiprinter-NBS-SL856B-Bluetooth-Device-fig-5

Standby Time

  • Standby for 10 min
  • Standby for 1 Hour(default)
  • Do not power off automaticallyminiprinter-NBS-SL856B-Bluetooth-Device-fig-5

Scanning mode

  • Barcode from Paperminiprinter-NBS-SL856B-Bluetooth-Device-fig-9
  • Barcode from Screenminiprinter-NBS-SL856B-Bluetooth-Device-fig-10miniprinter-NBS-SL856B-Bluetooth-Device-fig-8

Documents / Resources

miniprinter NBS-SL856B Bluetooth Device [pdf] Installation Guide
NBS-SL856B Bluetooth Device, NBS-SL856B, Bluetooth Device, Device

References

Leave a comment

Your email address will not be published. Required fields are marked *