WM 09 Wireless Audio Module
User ManualGetting Started Guide

CONNECT WATERPROOF HEADPHONES

CONNECT STANDARD HEADPHONES

TURN ON

PAIR TO DETECTOR (FIRST-USE)

TURN OFF

RECONNECT TO PREVIOUSLY PAIRED DETECTOR

PAIRING TIMEOUT

PAIR TO DIFFERENT DETECTOR (AFTER FIRST-USE)

LOW BATTERY

CHARGING

 

CARE AND MAINTENANCE — WM 09 WIRELESS AUDIO MODULE

• Keep the Headphone Socket clean and dry. Always replace the Dust Cap when not in use.
• The WM 09 is only waterproof when Minelab waterproof headphones are connected to the Headphone Socket.
• Do not connect any headphones if the Headphone Socket is damp or wet.
• Before charging, make sure the Magnetic Charging Connector is clean, dry and free of debris and salt residue.
• Do not clean the Magnetic Charging Connector with abrasives or chemicals.
• If the Magnetic Charging Connector contacts are corroded, gently clean with a soft pencil eraser.
• Do not clean the WM 09 with chemicals — wipe with a damp cloth or use soapy water if needed.
• The WM 09 contains an internal lithium battery — only dispose of the product in accordance with local regulations.
• Do not charge the battery in temperatures outside of the charging temperature range (0°C to 40°C/ 32°F to 104°F).

Minelab reserves the right to introduce changes in design, equipment and technical features at any time without notice.
Minelab® and WM09® are trademarks of Minelab Electronics Pty Ltd.
Minelab Electronics, PO Box 35, Salisbury South, South Australia 5106 Visit www.minelab.com/support
4901-0510-001-1

Documents / Resources

MINELAB WM 09 Wireless Audio Module [pdf] User Manual WM 09 Wireless Audio Module, WM 09, Wireless Audio Module, Audio Module, Module

References

• User Manual