Milody Smart Remote Control

Specifications
- Compliance: Part 15 of the FCC Rules
- Radiation Exposure Limits: FCC approved for uncontrolled environments
- Minimum Distance: 0cm between radiator and body
Product Usage Instructions
Safety Precautions
Before using the device, please read and understand the following safety precautions:
- Do not make any changes or modifications to the device that are not explicitly approved by the manufacturer.
- Ensure that there is a minimum distance of 0cm between the device’s radiator and your body during operation.
- Avoid exposing the device to extreme temperatures or moisture.
Installation
Follow these steps to install the device:
- Place the device on a stable and flat surface.
- Connect the necessary cables and power source as outlined in the user manual.
- Ensure proper ventilation around the device to prevent overheating.
Operation
To operate the device:
- Turn on the device using the power button.
- Follow the on-screen instructions or refer to the user manual for specific functions.
- Adjust settings as needed for optimal performance.
Maintenance
Regular maintenance can help prolong the life of your device:
- Clean the device with a soft, dry cloth to remove dust and debris.
- Avoid using harsh chemicals or solvents that may damage the device’s exterior.
- Check for software updates periodically to ensure smooth operation.
Functional Instructions

Download Smart Ligh1 Control APP Scan 1hc QR Code Below.

APP and Lamp Pairing Methods
- iPhone or Android/Huawei can be downloaded and installed automatically by scanning the QR code on the instructions.
- iPhone can be downloaded directly by accessing the APP STORE and searching Smart Light Control.
- Android phones can be downloaded directly by entering the application market to search for Smart Light Control. The
- Huawei Mobile phone can be downloaded directly by accessing the App Store and searching for Intelligent Light Control.

SETUP
CODING MODE
Press this button once in 10 seconds after the lamp has been powered on
After the lamp is electrified, press the SETUP key (code key) on the remote control quickly in 10 seconds. The light flashes indicate the code is successful. Otherwise, turn off the total power
Supply the lamp, a nd then repeat this step until the light Flashes and the alternation is successful
Long press or click this button, brightness will increase
Long press or click this button, brightness will reduce.
Long press this button the color temperature increases, and the light’s color turns white
Long press this button, and the color temperature drops, and the light’s color turns warm
Press this button the lamp turns into warm light(3000K)
Press this button and the lamp turns into white light (5700K)
Click this button to switch the color temperature between white light, warm light,a nd neutral light
Press this button to switch the lamp between full power and half power, er and the color temperature of the lamp is neutral light.
Memory IC: turn on the light next time and remember the state before turning off the light last time
FAQs
Q: What should I do if the device is not powering on?
A: Check the power source and connections to ensure they are secure. If the issue persists, contact customer support for further assistance.
Q: Can I modify the device for additional features?
A: No, any modifications not approved by the manufacturer may void the warranty and compromise the device’s operation.
Documents / Resources
![]() | Smart Remote Control |
References
- User Manualmanual.tools
