microtech Footswitch for MDS Windows APP
Footswitch for MDS Windows APP
FOOTSWITCH SETTING
- Install the actual software for setting Footswitch from USB drive with MDS v.5.0
- To setup Footswitch connection – connect Footswitch to PC using USB cables (from set) and run installed Foot switch software
- On “Custom Key” tab necessery to hold Ctrl+Enter keys at the same time.
- Click “Save to key” to complete the setting.
CONNECTION
- It’s possible to use USB or Wireless footswitch conneciton
- To activate Wireless Footswitch connection – add new Bluetooth device in Windows system and pair.
- Once connected it, it will be works for your device hands-free.
Note: Red Led: Reconnect status
Green Light: Working status
Red & Green :Pairing mode - Launch MDS App and save measurements values by bushing the Foot switch pedal
ENERGY SAVING MODE
- Foot pedal switch will enter into sleep mode if there is no operation or disconnection for 10 minutes to save energy.
- For activating your sleeping ,just press pedal to wake it up and reconnect automatically with the previously paired device.
SPECIFICATION
- Single Pedal Size: 5.55»x5.15»x1.38» / 141x131x35mm
- Weight: 8.46oz (240g)
- Length of the USB cable: 1.5M/4.9FT
- Battery: 2x AA batteries
MICROTECH
- innovative measuring instruments
- 61001, Kharkiv, Ukraine, str. Rustaveli, 39
- tel.: +38 (057) 739-03-50
- www.microtech.ua.
- tool@microtech.ua.
since 1995 www.microtech.ua ISO 17025 ISO 9001:2015.
Documents / Resources
 |
microtech Footswitch for MDS Windows APP [pdf] Instruction Manual Footswitch for MDS Windows APP, MDS Windows APP, Windows APP, APP |