MCS-NITROMAG-15.4
Customer Installation Wiring
MCS-NITROMAG-15.4 CUSTOMER
INSTALLATION
MCS-IO-BASE WiFi – 2.4 GHz Nitro Mag
- Remove all nuts from back of the touchscreen (10).
- Separate the face of the touchscreen from the Vesa Mount back.
- Lay the template (printed sheet supplied) on your enclosure, mark area for the cutout, 15.75 x 10.875 (40.05 x 27.6225cm).
- Mark the 10 holes to drill.
- Drill bit size – 3/16in (5mm).
- Cut out the hole for the touchscreen.
- Place the Touchscreen Face Plate through the cutout and secure the “4” corner ‘A’ nuts to the enclosure.
- Place the Vesa-Mount back onto the face plate studs, secure the remaining 8 nuts, making sure you do not over tighten the nuts. Tightening each nut around the frame, so the gasket is not pinched. Torque value 1 lbf.in
https://mcscontrols.com/NitroMag.html
Wiring Diagram
Note: ALL 12V WIRING MUST BE 18-Gauge MINIMUM
June 11, 2025 11:16 AM
5580 Enterprise Pkwy, Fort Myers, FL 33905 USA
Office: 239-694-0089 – Fax: 239-694-0031
www.mcxcontrols.com – support@mcscontrols.com
Documents / Resources
 |
MICRO CONTROL SYSTEM MCS-IO-BASE WiFi - 2.4 GHz Nitro Mag [pdf] Instruction Manual MCS-NITROMAG-15.4, MCS-IO-BASE, MCS-ETHERNET-SWITCH-B, MCS-IO-BASE WiFi - 2.4 GHz Nitro Mag, MCS-IO-BASE, WiFi - 2.4 GHz Nitro Mag, Nitro Mag |