yangchi Button Switch Instruction Manual

yangchi Button Switch

Nga korero hua

Ingoa Hua: Whakawhiti
Tau puranga/rangatū: Tahuri Pātene

Manufacturer & Eu Representative Info

Kaihanga:
Ingoa Kamupene: Guangzhou yangchi auto parts co. LTD
Wāhi noho: CN-2 # 1003 min joke Chuang, mining key ji yuan, tai he zhen, baryon district, Guangzhou.
Ī-Mēra: ouyan99@dingtalk.com
Waea: 86-13421389711
Māngai Whaimana a EU:
Ingoa Kamupene: CET PRODUCT SERVICE LTD
Wāhi noho: Osterholzallee 144 , 71636 Ludwigsburg Germany
Ī-Mēra: info.cetservice@gmail.com
Waea: Waea: +4971416432236

Nga Korero Tautukunga

eVatmaster Consulting GmbH Bettinastr. 30 60325 Frankfurt am Main, Tiamana contact@evatmaster.com

OST_EU_20220224000026

He māngai EC noa iho mātou mō ngā kaihoko whakawhiti-rohe, ehara hoki mātou i te kaihanga/kaikawemai/kaituku mō te hua, ehara hoki mātou i te whai wāhi ki te hanga/kaikawemai/hoko o te hua. Nō reira, kāore mātou e whai kawenga mō ngā ratonga whai muri i te hoko e pā ana ki te hua. Mēnā he take kounga hua, he take takahi ture rānei, ko te kaihanga/kaikawemai/kaihoko anake te kawenga.

FAKATOKANGA: This product must comply with all applicable safety and regulatory requirements in the market where it is sold. Sellers must assess which requirements and regulations apply based on the actual product type, function, and destination market.

Haumaru me nga Whakatupato

Nga Korero Haumaru Nui

Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.\r\n·
Whakatupato: Keep the device and its cord out of reach of children under 3 years old.\r\n· Keep away from children unless supervised by an adult.\r\n·
Do not use this product for purposes other than its intended use.\r\n· Inspect the product before each use; do not use if damaged.\r\n· Follow installation and operation guidelines to avoid injury.\r\n.

Tohutohu Mo te Whakamahi

How to Replace a Faulty Window Switch:

Hipanga 1: Disconnect the negative battery terminal before working on the switch to prevent short circuit. Next, unclip the handles using a screw driver. Lift the faulty switch out of its harness.
Hipanga 2: If you don’t want to take off the door casing or the door handle, simply slide a flat-head screwdriver under The switch bezel and pry it until it loosens to access the housing.
Hipanga 3: Once the switch pops out of the bezel, disconnect it from the wire harness and detach it from the outlet. Remove the rockers before inserting a new switch into the harness holes.
Hipanga 4: Assemble the rockers into the new switch and snap the device into the bezel.