Installation Guide for VELOSSA TECH models including: 2016-2018 Camaro SS BIG MOUTH Ram Air Intake, Camaro SS BIG MOUTH Ram Air Intake, SS BIG MOUTH Ram Air Intake, BIG MOUTH Ram Air Intake, Ram Air Intake, Air Intake, Intake
VELOSSA TECH Big Mouth Ram Air Intake Snorkel for Chevrolet Camaro SS – DMZ Auto When people see that massive inlet flare through the grille, they'll know it's Velossa Tech!
2017-2023 Chevrolet Camaro ZL1 and 2016-2018 Camaro SS BIG MOUTH Ram Air Intake Snorkel | Velossa Tech Design
2017-2023 Chevrolet Camaro ZL1 and 2016-2018 Camaro SS BIG MOUTH Ram Air Intake Installation Guide Kit Contents Please review this document before attempting installation. You will need basic hand tools and about 2 hours of installation time. Please review the table below and make sure you have received the kit contents. Description M6 x 65mm socket head cap screw M6 x 100mm socket head cap screw Steel mount plate M6 lock nut Qty in kit # 1 1 1 2 Stock Components Removal Get access to the area shown below by removing the top screws bumper screws and wheel well screws of the bumper. Complete bumper removal is not necessary, just the top portion of the bumper to allow access to the cowl. Using a jack on the driver's side is suggested since it helps the bumper sit lower. Stock Components Removal Begin by removing the 3 ribbed clips that hold this plastic piece to the radiator shroud and crash bar. Use a non-marring pry tool to assist you. Stock Component Removal The Big Mouth is meant to be tucked as shown below. Ensure that the cradle mounting region grips the diagonal crossbeam. Push the rightmost area up against the headlight and push down. Push in this direction to seat part, fully. Cradle Diagonal cross beam is here Push in this direction to seat part, fully. Big Mouth Installation Place the mount plate behind the crossbeam and insert the 65mm bolt through the right-side hole. Spin the nut on by hand, do not tighten yet. Insert the 100mm bolt in the passenger side hole and begin tightening both nuts in an alternating pattern, SNUG IS ENOUGH. Mount plate Use a 10mm wrench for the lock nuts and a 5mm Allen key for the bolt. DO NOT OVERTIGHTEN. Finalize Re-install the bumper the same way it was removed and ENJOY!Microsoft PowerPoint for Microsoft 365