SenseCAP M2 Multi Platform Gateway
“
Specifications:
- Model: SenseCAP M2
- Optional accessories for Wx9xx series transmitters
- Manufacturer: COMET SYSTEM, s.r.o.
- Address: Bezrucova 2901 756 61 Roznov pod Radhostem, Czech
Republic - Product Type: Gateway
Product Description and Use:
The SenseCAP M2 is a gateway designed as optional accessories
for Wx9xx series transmitters. It is used to connect the
transmitters to the COMET Cloud for data transmission and
monitoring.
Installation and Configuration:
- Configure the gateway via WiFi following the instructions in
the original device manual. - To register the gateway to the COMET Cloud, go to
Administration > LoRa Gateways menu. - Add the gateway to the list by entering its Gateway EUI
identifier (found on the label at the bottom of the device). - You can provide a name and location for the gateway on the map
for easier identification. - Connect the gateway to power and ensure it is connected as per
the recommended setup.
Recommended Gateway Connection:
To maintain cybersecurity, it is advised to connect the gateway
to a separate VLAN. Follow the image below for correct connection.
Once connected, the gateway status should change to ONLINE in the
cloud.
FAQ:
Q: What should I do if I need to reset the gateway to factory
settings?
A: Resetting the gateway will result in the
loss of all presets. To reset, follow the instructions provided in
the user manual carefully.
Q: How do I know if my gateway is properly connected?
A: Check the gateway list in the COMET Cloud;
if the status changes to ONLINE and the indicator on the front
surface turns permanently green, your gateway is connected
correctly.
“`
Gateway SP042 to the LoRaWAN® network. For COMET Cloud
QUICK START MANUAL
DESCRIPTION AND USE
model SenseCAP M2 – optional accessories for Wx9xx series transmitters
The gateway serves as an access point for the local LoRaWAN® network and is designed to connect COMET Wx9xx series transmitters to the COMET Cloud via the LoRaWAN® network. The gateway is a third-party product, supplied with complete original accessories for its power supply and installation. However, it is preset so that after installation it immediately starts receiving data messages from the LoRaWAN® network with its antenna, supplements them with the correct time of message receipt and sends the complete data to the target server used by the COMET Cloud. The condition is a connection to a network with available Internet, without restrictions on the outgoing direction from the gateway, e.g. by a firewall. A DHCP server must also be available in this network.
The gateway is configured via WiFi, see the original device manual. Under normal circumstances, it is not necessary to interfere with the gateway configuration, it is already set.
Warning: if you reset the gateway to factory settings, all presets will be lost!
Registering a gateway to the COMET Cloud is done in the Administration / LoRa Gateways menu. Add your gateway to the list by entering its Gateway EUI identifier (for this gateway, it is the EUI item from the label on the bottom of the device). You can also give it a suitable name and, if it will be placed stationary, we recommend entering its location on the map.
Connect the gateway as shown in the image below. To maintain cybersecurity, we recommend connecting the gateway to a separate VLAN. Connect the registered gateway to power. Within a few minutes, its status in the gateway list in the cloud must change to ONLINE and the green indicator on the front (white) surface of the gateway must then be permanently green.
RECOMMENDED GATEWAY CONNECTION
COMET SYSTEM, s.r.o., Bezrucova 2901 756 61 Roznov pod Radhostem, Czech republic
Specifications are subject to change without notice. IE-WFS-N-SP042-01
Documents / Resources
 |
MET SenseCAP M2 Multi Platform Gateway [pdf] User Guide SenseCAP M2 Multi Platform Gateway, SenseCAP M2, Multi Platform Gateway, Platform Gateway, Gateway |