Mercury Netcomm NF15AC WiFi Router User Manual

 

Netcomm NF15ACV Fibre Configuration

Using your own router? No worries, we’ve got you covered!

 

Log into the gateway:

1. Ensure your device is connected to the Router (preferably via cable)
2. Open a web browser
3. Type the following in the address bar at the top: 192.168.20.1
4. Default Username: admin
5. Default Password: password

This should then give access to the router’s user interface

(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds)

 

How to add correct settings for the Mercury network:

1. From the menu on the left select: WAN
2. From the sub-menu select: Ethernet WAN

 

Ensure the following settings are changed:

1. Enable VLAN: Ticked
2. Channel Mode: PPPoE
3. Enable NAPT: Ticked
4. Enable QoS: Ticked
5. Admin Status: Enable
6. MTU: 1492
7. Connection Type: Internet
8. IP Protocol: IPv4
9. PPP Username: (your mercury acct number)@mercurybroadband.co.nz
10. PPP Password: password
11. Type: Continuous
12. Authentication Method: Auto
13. AC-Name: (Left Blank)
14. Service Name: (Left Blank)
15. Select: Apply Changes

You should now be connected to Fibre!

 

Read More About This Manual & Download PDF:

Documents / Resources

Mercury Netcomm NF15AC WiFi Router [pdf] User Manual Netcomm NF15AC WiFi Router, Netcomm NF15AC, WiFi Router, Router

References

• User Manual