Mengquan V01 PLAT Max Table Lamp With Wireless Device Instruction Manual

V01 PLAT Max Table Lamp With Wireless Device

Product Information

Specifications:

  • Model: [Insert Model Number]
  • Compliance: FCC Part 15
  • Operating Conditions: Indoor use only
  • Distance Requirement: Minimum 20cm between device and user’s
    body

Product Usage Instructions

1. FCC Compliance

This device complies with part 15 of the FCC Rules. Users must
adhere to the following conditions:

  1. The device must not cause harmful interference.
  2. The device must accept any received interference, even if it
    leads to undesired operation.

2. Installation and Operation

Follow these guidelines for proper installation and
operation:

  • Reorient or relocate the receiving antenna if necessary.
  • Increase the separation between the equipment and the
    receiver.
  • Connect the device to a power outlet on a different circuit
    from the receiver.
  • If needed, seek assistance from the dealer or a qualified
    radio/TV technician.

3. RF Warning for Mobile Device

For mobile device usage, ensure compliance with the
following:

  • Operate the equipment with a minimum distance of 20cm between
    the radiator and your body.

Frequently Asked Questions (FAQ)

Q: What should I do if I encounter interference with the
device?

A: If interference occurs, try reorienting the antenna,
increasing separation from other equipment, or consult a
professional for assistance.

Q: Is it safe to use the mobile device close to my body?

A: To ensure safety, maintain a minimum distance of 20cm between
the device and your body when in operation.

“`

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Mobile device: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Documents / Resources

Mengquan V01 PLAT Max Table Lamp With Wireless Device [pdf] Instruction Manual
V01 PLAT Max Table Lamp With Wireless Device, PLAT Max Table Lamp With Wireless Device, Table Lamp With Wireless Device, Lamp With Wireless Device, Wireless Device

References

Leave a comment

Your email address will not be published. Required fields are marked *