MEDINAH POWER STR-MS Microwave Motion Sensor
OVERVIEW
SPECIFICATIONS
- Power supply
- 12V DC
- HF System
- 5.8GHz±75MHz
- Dim control output
- 0-10V, max. 25mAsinking current
- Detection radius/angle
- Max 16ft.(5m)/360°
- Mounting height
- Max 12ft
- Remote range
- 50ft. (15m) indoor, no backlight
- Humidity
- Max. 95% RH
- Temperature
- -40°F – 158°F (-40°C – 70°C)
NOTE: The high-frequency output of this sensor is <O. 2mW-that is just one 5000th of the transmission power of a mobile phone or the output of a microwave oven.
SENSOR COVERAGE
Once powering the device up, the ANT-9C will use factory default parameters to operate. If adjustments are needed, the “RC-100 “Wireless IR Configuration tool must be used.
UTILIZING FIELD AND INTRODUCTION
ANT-9Cis a moving object sensor that can detect a range of 360°and its working frequency is 5.8GHz. The advantage of this product is a stable working state (stable working temperature: -40°C-+ 70°C), ANT-9Cadopts a microwave sensor(high-frequency output <0.2mW), so that it is safe and performs better than an infrared sensor.
FUNCTION AND OPTIONS
The microwave sensor achieves tri-level dimming control, for some areas that require a light change notice before switch off. It offers 3 levels of the light Control: 100%–dimming light (0/10%/30%/50%)–off; and 2 periods of selectable waiting time: motion hold-time and stand-by time, Selectable daylight threshold, and choice of detection area.
- With suffcient natural light, the light does not switch on when presence is detected.
- With insufficient natural light, the sensor switches on the light automatically when a person enters the (options) standby level after entering the room. The lamp never switches off with the presence, even the natural light is sufficient.
- People left, lamp still dims to 0/10%/30%/50% (options) standby level after the hold time.
- The light switches off automatically after the dimming time has elapsed.
WIRING DIAGRAMS
ANT-9C wiring with dimming ballast or LED driver.
Frequently Asked Questions
Q: What is the purpose of the dim control output?
A: The dim control output allows you to adjust the lighting levels based on the sensor’s detection, enabling energy savings and customized lighting settings.
Q: Can the sensor be used outdoors?
A: The sensor is designed for indoor use only due to its specified detection range and environmental limitations.
Documents / Resources
 |
MEDINAH POWER STR-MS Microwave Motion Sensor [pdf] Instruction Manual STR-MS, STR-MS-ANT-9C, STR-RC, STR-MS Microwave Motion Sensor, Microwave Motion Sensor, Motion Sensor, Sensor |