MEAN WELL PS-05-5 5W Single Output Switching Power Supply

Product Information

The PS-05 series is a 5W single-output switching power supply. It is designed and tested to meet safety standards including BS EN/EN62368-1, TPTC004, and IEC62368-1. This power supply is available in five different models: PS-05-5, PS-05-12, PS-05-15, PS-05-24, and PS-05-48. Each model provides a different DC voltage output.

Model	DC Voltage	Rated Current	Current Range	Rated Power
PS-05-5	5V	1A	0 ~ 1.2A	5W
PS-05-12	12V	0.45A	0 ~ 0.5A	5.4W
PS-05-15	15V	0.35A	0 ~ 0.4A	5.25W
PS-05-24	24V	0.22A	0 ~ 0.25A	5.28W
PS-05-48	48V	0.11A	0 ~ 0.125A	5.28W

The power supply has a maximum ripple and noise of 100mVp-p. It features line regulation and load regulation for stable output performance. The setup and rise time is 1000ms with a rise time of 20ms. The hold-up time at full load is typically 100ms.

It accepts a wide voltage range from 85VAC to 264VAC or 120VDC to 370VDC, covering different power input scenarios. The frequency range is between 47Hz and 63Hz. The power supply has an efficiency rating of approximately 70% to 76% depending on the model. The AC current ranges from 0.15A to 0.07A, and the inrush current during cold start is typically 30A at 230VAC.

Product Usage Instructions

1. Ensure that the input voltage matches the specified range of 85VAC to 264VAC or 120VDC to 370VDC.
2. Connect the power supply to the desired device using appropriate wiring and connectors.
3. Verify that the DC voltage output required by your device matches the selected model of the power supply.
4. Turn on the power supply using the designated power switch if available.
5. Monitor the output voltage to ensure it is within the acceptable range for your device.
6. If necessary, adjust the load within the current range specified for the selected model.
7. Observe the power supply for any abnormal behavior or excessive ripple and noise.
8. In case of any issues or concerns, refer to the user’s manual or contact the manufacturer for support.

5W Single Output Switching Power Supply

FEATURES

• Universal AC input / Full range
• Low leakage current <O.5mA
• Protections: Short circuit / Overload / Over voltage / Over temperature
• Cooling by free air convection
• 100% full load burn-in test
  • Fix switching frequency at 67KHz
  • Low cost
• High reliability
• 2 years warrantv

SPECIFICATION

MODEL		PS-05-5	PS-05-12	PS-05-15	PS-05-24	PS-05-48
OUTPUT	DC VOLTAGE	5V	12V	15V	24V	48V
	RATED CURRENT	1A	0.45A	0.35A	0.22A	0.11A
	CURRENT RANGE	0 ~ 1.2A	0 ~ 0.5A	0 ~ 0.4A	0 ~ 0.25A	0 ~ 0.125A
	RATED POWER	5W	5.4W	5.25W	5.28W	5.28W
	RIPPLE & NOISE (max.) Note.2	100mVp-p	120mVp-p	120mVp-p	200mVp-p	200mVp-p
	VOLTAGE TOLERANCE Note.3	±2.0%	±2.0%	±2.0%	±2.0%	±1.0%
	LINE REGULATION	±1.0%	±1.0%	±1.0%	±0.5%	±0.5%
	LOAD REGULATION	±1.0%	±1.0%	±1.0%	±0.5%	±0.5%
	SETUP, RISE TIME	1000ms, 20ms
	HOLD UP TIME(Typ.)	100ms at full load
INPUT	VOLTAGE RANGE	85 ~ 264VAC          120 ~ 370VDC
	FREQUENCY RANGE	47 ~ 63Hz
	EFFICIENCY(Typ.)	70%	75%	75%	76%	76%
	AC CURRENT (Typ.)	0.15A/115VAC            0.07A/230VAC
	INRUSH CURRENT (Typ.)	COLD START 30A/230VAC
	LEAKAGE CURRENT	<0.5mA / 240VAC
PROTECTION	OVERLOAD	Above 105% rated output power
		Protection type : Hiccup mode, recovery automatically after fault condition is removed
	OVER VOLTAGE	5.75 ~ 6.75V	13.8 ~ 16.2V	17.2 ~ 20.2V	27.6 ~ 32.4V	55.2 ~ 64.8V
	OVER TEMPERATURE	Hiccup mode, recovery automatically after fault condition is removed
ENVIRONMENT	WORKING TEMP.	-10 ~ +60℃ (Refer to “Derating Curve”)
	WORKING HUMIDITY	20 ~ 90% RH non-condensing
	STORAGE TEMP., HUMIDITY	-20 ~ +85℃, 10 ~ 95% RH
	TEMP. COEFFICIENT	±0.05%/℃ (0 ~ 50℃)
	VIBRATION	10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC (Note 4)	SAFETY STANDARDS	TUV BS EN/EN62368-1,EAC TP TC 004 approved, IEC62368-1 CB approved by TUV
	WITHSTAND VOLTAGE	I/P-O/P:3KVAC
	ISOLATION RESISTANCE	I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
	EMI CONDUCTION & RADIATION	Compliance to BS EN/EN55032 (CISPR32) Class B, EAC TP TC 020
	HARMONIC CURRENT	Compliance to BS EN/EN61000-3-2,-3
	EMS IMMUNITY	Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN55035, light industry level, EAC TP TC 020
OTHERS	MTBF	6873.2K hrs min.       Telcordia SR-332 (Bellcore) ; 1271.1K hrs min.        MIL-HDBK-217F (25℃)
	DIMENSION	75*40*20mm (L*W*H)
	PACKING	0.05Kg; 120pcs/6.25Kg/0.56CUFT
NOTE	All parameters NOT specially mentioned are measured at 230VAC input, rated load and 250C of ambient temperature. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a O.Iuf & 47uf parallel capacitor. Tolerance : includes set up tolerance, line regulation and load regulation. The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 360mm*360mm metal plate with Imm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on http://www.meanwell.com)  The ambient temperature derating of 3.50C/1000m with fanless models and of 50C/1000m with fan models for operating altitude higher than 2000m(6500ft). https://www.meanwell.com/serviceDisclaimer.aspx

Mechanical Specification

• AC Input Connector (CN2) : Molex 5285-03 or equivalent
  

  Pin No.	Assignment			Mating Housing	Terminal
  1	FG			Molex 5058 or equivalent	Molex 2478 or equivalent
  2	AC/N
  3	AC/L

• DC Output Connector (CN1) : Molex 5273-02 or equivalent
  

  Pin No.	Assignment	Mating Housing	Terminal
  1	+V	Molex 5195 or equivalent	Molex 5194 or equivalent
  2	-V

Mechanical Specification

Block Diagram

Derating Curve

Static Characteristics

File Name: PS-05-SPEC  2022-09-20

Downloaded from Arrow.com.

User’s Manual

GTIN CODE
MW Search: https://www.meanwell.com/serviceGTlN.aspx

Documents / Resources

MEAN WELL PS-05-5 5W Single Output Switching Power Supply [pdf] Owner's Manual PS-05-5 5W Single Output Switching Power Supply, PS-05-5, 5W Single Output Switching Power Supply, Output Switching Power Supply, Switching Power Supply, Power Supply, Supply

References

• User Manual