MEAN WELL PLD-60 Single Output LED Power Supply
Features
- Built-in active PFC function
- Constant current design
- Protections: Short circuit / Over temperature
- Cooling by free air convection
- Fully isolated plastic case
- IP42 design
- Class II power unit, no FG
- Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)
- 100% full load burn-in test
- Low cost
- High reliability
- 3 years warranty
GTIN CODE
MW Search: https://www.meanwell.com/serviceGTIN.aspx
SPECIFICATION
MODEL | PLD-60-500B | PLD-60-700B | PLD-60-1050B | PLD-60-1400B | PLD-60-1750B | PLD-60-2000B | PLD-60-2400B | |
OUTPUT |
RATED CURRENT | 500mA | 700mA | 1050mA | 1400mA | 1750mA | 2000mA | 2400mA |
OPERATING VOLTAGE RANGE | 70 ~ 108V | 50 ~ 86V | 34 ~ 57V | 25 ~ 43V | 20 ~ 34V | 18 ~ 30V | 15 ~ 25V | |
CURRENT ACCURACY | ±5.0% | |||||||
RATED POWER | 54W | 60.2W | 59.85W | 60.2W | 59.5W | 60W | 60W | |
RIPPLE & NOISE (max.) Note.1 | 10.2Vp-p | 5.6Vp-p | 3.8Vp-p | 3.4Vp-p | 3.3Vp-p | 2.4Vp-p | 2.4Vp-p | |
NO LOAD OUTPUT VOLTAGE (max.) | 118V | 100V | 63V | 50V | 50V | 35V | 35V | |
SETUP TIME | 500ms / 230VAC at full load | |||||||
INPUT |
VOLTAGE RANGE | 180~295VAC | ||||||
FREQUENCY RANGE | 47 ~ 63Hz | |||||||
POWER FACTOR (Typ.) | PF>0.9/230VAC, PF>0.9/277VAC at full load (Please refer to “Power Factor Characteristic” curve) | |||||||
TOTAL HARMONIC DISTORTION | THD< 20% when output loading≧60%(PLD-60-500B loading≧65%)at 230VAC input and output loading≧75% at 277VAC input | |||||||
EFFICIENCY (Typ.) | 88% | 87% | 87% | 86% | 86% | 86% | 86% | |
AC CURRENT (Typ.) | 0.6A/230VAC 0.5A/277VAC | |||||||
INRUSH CURRENT(Typ.) | COLD START 25A (twidth=60μs measured at 50% Ipeak) at 230VAC | |||||||
MAX. No. of PSUs on 16A CIRCUIT BREAKER | 32 units (circuit breaker of type B) / 32 units (circuit breaker of type C) at 230VAC | |||||||
LEAKAGE CURRENT | <0.5mA / 240VAC | |||||||
PROTECTION | SHORT CIRCUIT | Hiccup mode, recovers automatically after fault condition is removed. | ||||||
OVER TEMPERATURE | Shut down o/p voltage, auto-recovery | |||||||
ENVIRONMENT |
WORKING TEMP. | -30 ~ +45℃ (Refer to “Derating Curve”) | ||||||
WORKING HUMIDITY | 20 ~ 95% RH non-condensing | |||||||
STORAGE TEMP., HUMIDITY | -40 ~ +80℃, 10 ~ 95% RH | |||||||
TEMP. COEFFICIENT | ±0.03%/℃ (0 ~ 50℃) | |||||||
VIBRATION | 10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes | |||||||
SAFETY & EMC |
SAFETY STANDARDS | ENEC BS EN/EN61347-1, BS EN/EN61347-2-13 independent, BS EN/EN62384, BIS IS15885(for 700B,1050B,1400B only),
EAC TP TC 004, IP42 approved |
||||||
WITHSTAND VOLTAGE | I/P-O/P:3.75KVAC | |||||||
ISOLATION RESISTANCE | I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH | |||||||
EMC EMISSION | Compliance to BS EN/EN55015, BS EN/EN61000-3-2 Class C ; BS EN/EN61000-3-3, EAC TP TC 020 | |||||||
EMC IMMUNITY | Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN61547, light industry level(Surge 2KV), criteria B, EAC TP TC 020 | |||||||
OTHERS | MTBF | 4642.1K hrs min. Telcordia SR-332 (Bellcore) ; 458.9Khrs min. MIL-HDBK-217F (25℃) | ||||||
DIMENSION | 128*60*31.5mm (L*W*H) | |||||||
PACKING | 0.34Kg;30pcs/11.2Kg/0.58CUFT | |||||||
NOTE |
Product Liability Disclaimer : For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx |
Documents / Resources
![]() |
MEAN WELL PLD-60 Single Output LED Power Supply [pdf] Owner's Manual PLD-60-500B, PLD-60-700B, PLD-60-1050B, PLD-60-1400B, PLD-60-1750B, PLD-60-2000B, PLD-60-2400B, PLD-60 Single Output LED Power Supply, PLD-60, Single Output LED Power Supply, Output LED Power Supply, LED Power Supply, Power Supply, Supply |