Contents
hide
MEAN WELL PLD-16 Series 16W Single Output LED Power Supply
Features
- 115VAC or 230VAC models available
- Built-in active PFC function
- Constant current design
- Protections: Short circuit/ Over temperature
- Cooling by free air convection
- Fully isolated plastic case
- Class 2 Power Unit
- Class II power unit, no FG
- IP42 design Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)
- 100% full load burn-in test Low cost High reliability 3 years warranty
Specification
| MODEL | PLD-16-350 | PLD-16-700 | PLD-16-1050 | PLD-16-1400 | ||
| OUTPUT | RATED CURRENT | 350mA | 700mA | 1050mA | 1400mA | |
| OPERATING VOLTAGE RANGE | 24 ~ 48V | 16 ~ 24V | 12 ~ 16V | 8 ~ 12V | ||
| CURRENT ACCURACY | ±5.0% | |||||
| RATED POWER | 16.8W | 16.8W | 16.8W | 16.8W | ||
| RIPPLE & NOISE (max.) Note.1 | 4.6Vp-p | 2.7Vp-p | 2.2Vp-p | 2Vp-p | ||
| NO LOAD OUTPUT VOLTAGE (max.) | 60V | 35V | 25V | 16V | ||
| SETUP TIME | 500ms / 230VAC 2000ms / 115VAC at full load | |||||
| INPUT | FREQUENCY RANGE | 47 ~ 63Hz | ||||
| POWER FACTOR (Typ.) | PF>0.9/115VAC, PF>0.9/230VAC, PF>0.9/277VAC at full load (Please refer to “Power Factor Characteristic” curve) | |||||
| TOTAL HARMONIC DISTORTION | A series | THD< 20% when output loading≧70% at 115VAC | ||||
| B series | THD< 20% when output loading≧70% at 230VAC input and output loading≧80% at 277VAC input | |||||
| EFFICIENCY (Typ.) | A series | 84.5% | 84.5% | 84% | 82.5% | |
| B series | 85.5% | 86% | 85% | 83.5% | ||
| AC CURRENT (Typ.) | 0.4A/115VAC 0.2A/230VAC 0.15A/277VAC | |||||
| INRUSH CURRENT(Typ.) | COLD START 20A(twidth=25μs measured at 50% Ipeak) at 230VAC | |||||
| MAX. No. of PSUs on 16A CIRCUIT
BREAKER |
A series | 58 units (circuit breaker of type B) / 58 units (circuit breaker of type C) at 115VAC | ||||
| B series | 128 units (circuit breaker of type B) / 128 units (circuit breaker of type C) at 230VAC | |||||
| LEAKAGE CURRENT | <0.5mA / 240VAC | |||||
| PROTECTION | SHORT CIRCUIT | Hiccup mode, recovers automatically after fault condition is removed. | ||||
| OVER TEMPERATURE | Shut down o/p voltage, re-power on to recover | |||||
| ENVIRONMENT | WORKING TEMP. | -30 ~ +50℃ (Refer to “Derating Curve”) | ||||
| WORKING HUMIDITY | 20 ~ 95% RH non-condensing | |||||
| STORAGE TEMP., HUMIDITY | -40 ~ +80℃, 10 ~ 95% RH | |||||
| TEMP. COEFFICIENT | ±0.03%/℃ (0 ~ 50℃) | |||||
| VIBRATION | 10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes | |||||
| SAFETY & EMC | SAFETY STANDARDS | UL8750,CSA C22.2 No.250.0-08;ENEC BS EN/EN 613471-1,BS EN/EN 61347-2-13 independent, BS EN/EN62384(for B type only), EAC TP TC 004, IP42 approved | ||||
| WITHSTAND VOLTAGE | I/P-O/P:3.75KVAC | |||||
| ISOLATION RESISTANCE | I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH | |||||
| EMC EMISSION | Compliance to BS EN/EN55015 (B type only), BS EN/EN61000-3-2 Class C ; BS EN/EN61000-3-3, FCC part 18 non-consumer equipment(A type only), EAC TP TC 020 | |||||
| EMC IMMUNITY | Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN61547, light industry level, EAC TP TC 020 | |||||
| OTHERS | MTBF | 6807.7K hrs min. Telcordia SR-332 (Bellcore) ; 872.4Khrs min. MIL-HDBK-217F (25℃) | ||||
| DIMENSION | 84*57*29.5mm (L*W*H) | |||||
| PACKING | 0.19Kg; 72pcs/14.7Kg/0.92CUFT | |||||
| Note |
|
|||||
Mechanical Specification
Type:(PLD-16-_A)
Type:(PLD-16-_B)
Block Diagram
Derating Curve
Static Characteristics
Power Factor Characteristic
EFFICIENCY vs LOAD (PLD-16-350)
Documents / Resources
 |
MEAN WELL PLD-16 Series 16W Single Output LED Power Supply [pdf] Owner's Manual PLD-16 Series, 16W Single Output LED Power Supply, PLD-16 Series 16W Single Output LED Power Supply, Output LED Power Supply, LED Power Supply, Power Supply |
 |
MEAN WELL PLD-16 Series 16W Single Output LED Power Supply [pdf] User Guide PLD-16 Series 16W Single Output LED Power Supply, PLD-16 Series, 16W Single Output LED Power Supply, Output LED Power Supply, LED Power Supply, Power Supply, Supply |
