Contents hide
1 MEAN WELL LPV-35 Series Single Output Switching Power Supply
2 Product Information
3 Product Usage Instructions
4 Frequently Asked Questions
5 GTIN CODE
6 Features
7 SPECIFICATION
8 Documents / Resources
8.1 References

MEAN-WELL-logo

MEAN WELL LPV-35 Series Single Output Switching Power Supply

MEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-product

Product Information

Specification

  • Model: LPV-35 series
  • Output Input: DC Voltage
  • Rated Current: 5A, 3A, 2.4A, 1.5A
  • Rated Power: 30W, 36W
  • Ripple & Noise (max.): 80mVp-p, 120mVp-p, 150mVp-p
  • Efficiency (Typ.): 77%, 84%, 85%
  • Working Temperature: -30°C to +65°C
  • Working Humidity: 20% to 90% RH non-condensing
  • Safety Standards: UL1310 class 2, CAN/CSA No. 223-M91, BIS IS15885, IEC62368-1, EAC TP TC 004, IP67, BS EN/EN62368-1 approved

Product Usage Instructions

Installation

  1. Ensure the input voltage is within the specified range of 90 ~ 264VAC or 127 ~ 370VDC.
  2. Connect the output terminals to the device requiring power, ensuring correct polarity.
  3. If multiple units are used, verify the maximum number allowed on a circuit breaker.

Operation

  1. Power on the LPV-35 series power supply.
  2. Monitor the output voltage to ensure it matches the requirements of your device.
  3. In case of overload or overvoltage, the protection mechanisms will activate. Rectify the issue before re-powering on.

Maintenance

  1. Regularly check for dust accumulation and clean the unit if necessar.
  2. Inspect for any physical damage or loose connections that may affect performance.

Frequently Asked Questions

  • Q: What should I do if the LPV-35 series power supply overheats?
    • A: Ensure proper ventilation around the unit and check for any obstructions to airflow. If the issue persists, contact customer support.
  • Q: Can I use the LPV-35 series power supply outdoors?
    • A: Yes, the LPV-35 series is IP67 rated for outdoor use, providing protection against dust and water ingress.
  • Q: How do I know if the LPV-35 series power supply is compatible with my device?
    • A: Check the voltage and current requirements of your device against the specifications of the LPV-35 series to ensure compatibility.

GTIN CODE

MW Search: https://www.meanwell.com/serviceGTIN.aspxMEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-2

Features

  • Constant voltage design
  • Universal AC input / Full range
  • Withstand 300VAC surge input for 5 seconds
  • Protections: Short circuit / Overload / Over voltage
  • Cooling by free air convection
  • Fully encapsulated with IP67 level (Note.8)
  • Fully isolated plastic case
  • Class Il power unit, no FG
  • Class 2 power unit
  • Pass LPS
  • Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)(Note. 12)
  • 100% full load burn-in test
  • Low cost, high reliability
  • 2 vears warranty

SPECIFICATION

MEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-3

MODEL LPV-35-5 LPV-35-12 LPV-35-15 LPV-35-24 LPV-35-36
 

 

 

 

OUTPUT

 DC VOLTAGE 5V 12V 15V 24V 36V
RATED CURRENT 5A 3A 2.4A 1.5A 1A
CURRENT RANGE 0 ~ 6A (Note.7) 0 ~ 3A 0 ~ 2.4A 0 ~ 1.5A 0 ~ 1A
RATED POWER 30W 36W 36W 36W 36W
RIPPLE & NOISE (max.) Note.2 80mVp-p 120mVp-p 120mVp-p 150mVp-p 150mVp-p
VOLTAGE TOLERANCE Note.3 ±6.0% ±5.0%
LINE REGULATION ±1.0%
LOAD REGULATION ±4.0% ±2.0%
SETUP, RISE TIME           Note.6 500ms, 20ms / 230VAC  500ms, 20ms / 115VAC at full load
HOLD UP TIME (Typ.) 50ms/230VAC            16ms/115VAC at full load
 

 

INPUT

 VOLTAGE RANGE            Note.4 90 ~ 264VAC           127 ~ 370VDC
FREQUENCY RANGE 47 ~ 63Hz
EFFICIENCY (Typ.) 77% 84% 84% 85% 85%
AC CURRENT (Typ.) 1.1A/115VAC  0.7A/230VAC
INRUSH CURRENT(Typ.) COLD START 55A(twidth=510μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER 4 units (circuit breaker of type B) / 7 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT 0.25mA / 240VAC
 

PROTECTION

 OVERLOAD 110 ~ 150% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
OVER VOLTAGE 5.75 ~ 6.75V 13.8 ~ 16.2V 17.25 ~ 20.25V 27.6 ~ 32.4V 41.4 ~ 48.6V
Protection type : Shut down o/p voltage, re-power on to recover
 

 

ENVIRONMENT

 WORKING TEMP. -30 ~ +65℃ (Refer to “Derating Curve”)
WORKING HUMIDITY 20 ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT ±0.03%/℃ (0 ~ 50℃)
VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
 

 

SAFETY & EMC

 SAFETY STANDARDS UL1310 class 2, CAN/CSA No. 223-M91, BIS IS15885(Note 13), IEC62368-1, EAC TP TC 004, IP67, BS EN/EN62368-1 approved
WITHSTAND VOLTAGE I/P-O/P:3KVAC
ISOLATION RESISTANCE I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSION Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/EN61000-3-2 Class A, BS EN/EN61000-3-3, EAC TP TC 020
EMC IMMUNITY Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN55035, light industry level, EAC TP TC 020
 

OTHERS

 MTBF 5170.3K hrs min.       Telcordia SR-332 (Bellcore) ;          743.5Khrs min.       MIL-HDBK-217F (25℃)
DIMENSION 148*40*30mm (L*W*H)
PACKING 0.34Kg; 40pcs/14.6Kg/0.70CUFT
NOTE
  1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
  2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
  3. Tolerance : includes set up tolerance, line regulation and load regulation.
  4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
  5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.(as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)
  6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
  7. LPV-35-5 can provide 6A of output current continuously. Based on the requirement of UL1310 class 2, the output current is only certified up to 5A for the test report of LPV-35-5.
  8. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
  9. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
  10. Products sourced from the Americas regions may not have the TUV/BIS/CCC logo. Please contact your MEAN WELL sales for more information.
  11. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
  12. This product is not intended for LED lighting luminaire applications in the EU and China.(In the EU and China the LPF/NPF/XLG/XLC/XLN series are recommended.)
  13. Products sourced from the China regions may not

※ Product Liability Disclaimer：For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx
  • Mechanical Specification
    • Case No.975A
    • Unit:mm
    • Tolerance:+1MEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-4
  • Recommend Mounting DirectionMEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-5
  • Block DiagramMEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-6
  • Derating CurveMEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-7
  • Static CharacteristicsMEAN-WELL-LPV-35-Series-Single-Output-Switching-Power-Supply-fig-8

File Name:LPV-35-SPEC 2024-10-16

Documents / Resources

MEAN WELL LPV-35 Series Single Output Switching Power Supply [pdf] Owner's Manual
LPV-35 Series Single Output Switching Power Supply, LPV-35 Series, Single Output Switching Power Supply, Output Switching Power Supply, Switching Power Supply, Power Supply, Supply

References

Leave a comment

Your email address will not be published. Required fields are marked *