MEAN WELL LPV-100 Series 100W Single Output Switching Power Supply Owner's Manual

MEAN WELL LPV-100 Series 100W Single Output Switching Power Supply Owner’s Manual

Contents hide

1 Features:

2 SPECIFICATION

3 Mechanical Specification

4 Recommend Mounting Direction

5 Block Diagram

6 Aerating Curve

7 Static Characteristics

8 Documents / Resources

8.1 References

9 Related Posts

Features:

Constant voltage design
Universal AC input/ Full range

Fully encapsulated with IP67 level (Note.7)
Withstand 300VAC surge input for 5 seconds

Protections: Short circuit/Overload/Over voltage
Fully isolated plastic case

Cooling by free air convection
100% full load burn-in test

Low cost, high reliability
Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices) (Note.11)

2 years warranty

User’s Manual

SPECIFICATION

MODEL

LPV-100-5

LPV-100-12

LPV-100-15

LPV-100-24

LPV-100-36

LPV-100-48

OUTPUT

DC VOLTAGE

12V

15V

24V

36V

48V

RATED CURRENT

12A

8.5A

6.7A

4.2A

2.8A

2.1A

CURRENT RANGE

0 ~ 12A

0 ~ 8.5A

0 ~ 6.7A

0 ~ 4.2A

0 ~ 2.8A

0 ~ 2.1A

RATED POWER

60W

102W

100.5W

100.8W

RIPPLE & NOISE (max.) Note.2

80mVp-p

120mVp-p

150mVp-p

VOLTAGE TOLERANCE Note.3

±8.0%

±5.0%

LINE REGULATION

±1.0%

LOAD REGULATION

±6.0%

±2.0%

SETUP, RISE TIME

Note.6

2000ms, 25ms / 230VAC 2000ms, 25ms / 115VAC

HOLD UP TIME (Typ.)

50ms/230VAC 14ms/115VAC at full load

INPUT

VOLTAGE RANGE

Note.4

90 ~ 264VAC 127 ~ 370VDC

FREQUENCY RANGE

47 ~ 63Hz

EFFICIENCY (Typ.)

80%

85%

87%

88%

89%

AC CURRENT

2.2A/115VAC 1.2A/230VAC

INRUSH CURRENT(Typ.)

COLD START 75A(twidth=700μs measured at 50% Ipeak) at 230VAC

MAX. No. of PSUs on 16A CIRCUIT BREAKER

2 units (circuit breaker of type B) / 3 units (circuit breaker of type C) at 230VAC

LEAKAGE CURRENT

0.25mA / 240VAC

PROTECTION

OVERLOAD

110 ~ 150% rated output power

Protection type : Hiccup mode, recovers automatically after fault condition is removed

OVER VOLTAGE

5.75 ~ 6.75V

13.8 ~ 16.2V

17.25 ~ 20.25V

27.6 ~ 32.4V

41.4 ~ 48.6V

55.2 ~ 64.8V

Protection type : Shut down o/p voltage, re-power on to recover

ENVIRONMENT

WORKING TEMP.

-25 ~ +70℃ (Refer to “Derating Curve”)

WORKING HUMIDITY

20 ~ 90% RH non-condensing

STORAGE TEMP., HUMIDITY

-40 ~ +80℃, 10 ~ 95% RH

TEMP. COEFFICIENT

±0.03%/℃ (0 ~ 50℃)

VIBRATION

10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes

SAFETY & EMC

SAFETY STANDARDS

UL8750,CSA C22.2 No 250.13-12,UL879,CSA C22.2 No.207-M89,BIS IS15885(Note12),EAC TP TC 004,IP67, IEC62368-1 , BS EN/EN62368-1 approved

WITHSTAND VOLTAGE

I/P-O/P:3KVAC

ISOLATION RESISTANCE

I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH

EMC EMISSION

Compliance to BS EN/EN55032 (CISPR32) Class B, BS EN/EN61000-3-2 Class A(≤80% load), BS EN/EN61000-3-3, EAC TP TC 020

EMC IMMUNITY

Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11; BS EN/EN55035, light industry level, EAC TP TC 020

OTHERS

MTBF

4497.1K hrs min. Telcordia SR-332 (Bellcore) ;

681.6Khrs min.

MIL-HDBK-217F (25℃)

DIMENSION

190*52*37mm (L*W*H)

PACKING

0.63Kg;20pcs/13.6Kg/0.55CUFT

NOTE

All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
Tolerance : includes set up tolerance, line regulation and load regulation.
Derating may be needed under low input voltage. Please check the static characteristics for more details.
The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.(as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf)
Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time
Suitable for indoor use or outdoor use without direct sunlight exposure
The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
Products sourced from the Americas regions may not have the TUV/BIS/CCC logo. Please contact your MEAN WELL sales for more information.
For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPF/XLG series are recommended.)
R-41027766 (GZ factory) only for 12V,24V / R-62002178 (ID factory) for 5V~48V

※ Product Liability Disclaimer：For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx

Arrow.com.

File Name: LPV-100-SPEC 2024-02-19

Mechanical Specification

Recommend Mounting Direction

Block Diagram

Aerating Curve

Static Characteristics

Documents / Resources

	MEAN WELL LPV-100 Series 100W Single Output Switching Power Supply [pdf] Owner's Manual LPV-100 Series, LPV-100 Series 100W Single Output Switching Power Supply, 100W Single Output Switching Power Supply, Single Output Switching Power Supply, Switching Power Supply, Power Supply, Supply
	MEAN WELL LPV-100 Series 100W Single Output Switching Power Supply [pdf] Owner's Manual LPV-100-5, LPV-100-12, LPV-100-15, LPV-100-24, LPV-100-36, LPV-100-48, LPV-100 Series 100W Single Output Switching Power Supply, LPV-100 Series, 100W Single Output Switching Power Supply, Output Switching Power Supply, Switching Power Supply, Power Supply