Mc CAMPING MC-65L Compressor Built in Refrigerator Instruction Manual

Prepare the installation area ensuring proper ventilation and distance from heat sources.
Connect the refrigerator to a 12/24VDC power supply following the cable cross-section guidelines based on wire length.

Carefully push the fridge into the cabinet, ensuring the power cable is kept loose to avoid damage.

Product Usage

Temperature Control
The temperature control switch allows you to set the cooling level from low to high. Refer to the voltage references provided for each setting.

FAQ
Q: How do I defrost the freezer compartment?
A: To defrost the freezer compartment, turn off the refrigerator, remove all items, and let the ice melt naturally. Clean and dry the compartment before restarting the fridge.

SAFETY INSTRUCTIONS

WARNING!

Do not operate the appliance if it is visibly damaged.
Do not block the gaps of the fridge with things like pin, wire, etc.

Do not expose the appliance to rain or soak it in water.
Do not place the appliance near naked flames or other heat sources (heaters, direct sunlight, gas ovens etc.)

Do not store any explosive substances, like spray cans with a flammable propellant, in or near the fridge.
Ensure the supply cord is dry and not trapped or damaged. Do not locate multiple portable socket outlets or portable power supplies at the rear of the appliance.

Check the voltage specification on the type plate corresponds to that of the energy supply. The appliance is only to be used with the power supply unit provided with the appliance.
Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

Once unpacked and before turning on, the appliance must be placed on a level surface for more than 6 hours.
Make sure that the appliance stays horizontally when it is running. The tilt angle must be less than 5° for long-time running and be less than 45° for short time running.

Keep the ventilation openings in the unit casing or in the built-in structure free of obstacles. (Around the compressor ≥100 mm).
Keep the appliance stable on the ground or in the car. Do not drain upside down.

CAUTION

Repairs may only be carried out by qualified personnel. Incorrect repair may cause danger. The lamp and supply cord must be replaced by the manufacturer or qualified persons.
The installation of DC power must be handled by qualified electricians.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
The appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they‘ve been given supervision or instruction concerning use of the device in a safe way and understand the hazards.

NOTICE!

Disconnect the power supply before each cleaning and maintenance and after every use.
Do not use sharp tools to defrost. Do not damage the refrigerant circuit.
Check if the cooling capacity of the appliance is suitable for storing the food or medicine. Food may only be stored in its original packaging or in suitable containers.
If the appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent mould developing within the appliance.

Please observe the local regulations for the disposal of the unit due to the flammable refrigerant and blowing gas.

PRODUCT FEATURES

High-efficiency DC compressor from LG.
CFC free and great heat insulation.
Intelligent battery protection system prevents your vehicle from running out of battery.
LED display control panel for temperature setting, dual fridge and freezer zone.

Easy to install, reversible door.

PRODUCT STRUCTURE

INSTALLATION

Ensure that the fridge is not damaged when opening the package after receiving the product. Any transportation damage could be reported to the place of purchase. Handle the product with the utmost care and attention.

Prepare the cabinet: leave some space around the refrigerator to keep good ventilation. Always keep the fridge on a horizontal surface and away from heat sources.
There should be at least 50mm space at the rear and top of the refrigerator and 20mm on each side.
Product Dimensions MC-65L (unit mm)
Recommended
Installation Dimension:
- Qwidth: 510 mm
- height: 680 mm
- depth: 481 mm
Connect to a power supply: connect the refrigerator to the vehicle 12/24VDC system directly, the minimal cable cross-section as per the below table based on the overall length of wire between the refrigerator and the battery.
It is highly recommended that the installation fridge is carried out by a qualified person. Enough free wire needed to be kept for moving the fridge into the cabinet.

Wire Length to Refrigerator cable diameter

Maximum 6m 2.5 mm² (14AWG)

Maximum 11m 4.0 mm² (12AWG)

Maximum 17m 6.0 mm² (10AWG)
Push the fridge into the cabinet carefully to avoid scratching the floor and the power cable should be kept loosen.

Attach the fridge to the cabinet wall: the screw holder is built in the side wall of the refrigerator. A hole needs to be drilled through the screw holder into the side panel.
Use a screw (M5, 15mm minimum) and fix it on the wall. After that use the screw cover to cover the screw head (screws are not included).
Verify the installation: once the installation had been finished, check the continuity of the earth circuit and carry out all electrical safety testing provided by current regulations. Protect and fix the cables in order to prevent accidental pulling of the cable from disconnecting it from the con-nections or coming into contact with hot parts with a temperature above 50° C or with sharp parts.

REVERSIBLE DOOR

Reversible door that can be opened from left to right or from right to left. Follow the steps below if necessary:

Unscrew the bottom hinge and take off the door body (keep the fridge stable).
Unscrew and take off the door latch, and install it into the other side.
Move the top and bottom door axle to the other side, and install the door to the refrigerator; fas-ten the top and bottom door axles with the top and bottom hinges; screw the door with the hinges, the door opening direction is now reversed.

FUNCTION AND OPERATION

Power Supply: DC 12V/24V.

Display Screen Initialization: when the fridge is powered on, the buzzer will make a long beep and the display will be on.
Power ON/OFF: press to switch ON/OFF.
Switch Refrigeration/freezer: press to switch between refrigerator (the screen will flash „rE“) or freezer (the screen will flash „Fr“).

Temperature Setting: press + or – for temperature setting. The setting will be saved automatically after stopping operating for 4 seconds (Note: the temperature displayed is the current temperature of the compartment, it’ll take a while to reach the set temperature).
Battery Protection Mode: under the running state, long press for 3 seconds until the screen flashes, then press again to switch High, Medium and Low (*Factory setting is High).

From left to right: Low/Medium/High.

Voltage reference

INPUT MODE	DC 12V		DC 24V
INPUT MODE	CUT OUT	CUT IN	CUT OUT	CUT IN
L	8.5V	10.9V	21.3V	22.7V
M	10.1V	11.4V	22.3V	23.7V
H	11.1V	12.4V	24.3V	25.7V

The voltage is theoretical value, there may be a deviation in different sceneries.
H should be set when the product is connected to car power. M or L should be set when it is con-nected to a portable battery or other back-up battery.
Temperature Unit Setting: switch off the fridge, long press for 3 seconds until displays E1, and switch to E5 by pressing again, then press + or – to switch Celsius or Fahrenheit. (*Factory setting is °C.)

Reset: switch off the fridge, long press for 3seconds until displays E1, under E1 mode, long press + – at the same time for seconds to reset the settings
Recommended temperature for common food:

CARE AND MAINTENANCE

Cleaning:
- Switch off and unplug the device first to avoid electric shock.
- Use wet cloth to clean the device and dry it.
- Do not soak the fridge in water and do not wash it directly.
- Do not use abrasive cleaning agents during cleaning as these can damage the device.
Storage:
If the device will not be in use for a long time, please follow the instruction:
- Switch off and unplug the device.
- Take out all the items stored in the device.
- Wipe off excess water with a soft rag.
- Put the fridge in a cool and dry place.
- Leave the door slightly open to prevent odors from forming.
- Recommended storage environment: ambient temperature: 25°C, ambient humidity: ≤ 75%.

Defrosting:
Humidity can form frost in the interior of the cooling device or on the evaporator.
This reduces the cooling capacity. Defrost the device from time to time to avoid this.
- Switch off and unplug the device first to avoid electric shock.
- Take out all the items stored in the device.
- Keep the door open.
- Wipe off the defrosted water.
  Never use hard or pointed tools to remove ice or to loosen objects which have frozen in place.

TROUBLESHOOTING

Refrigerator does not work:

Check if the switch is on.
Check if the plug and socket are connected.
Check if the fuse has been burnt.

Check if the power supply is malfunctioned.
Switch on/off the fridge frequently may cause start delay of the compressor.
Refrigerator compartments are too warm:
The door is opened frequently.

A large amount of warm or hot food was stored recently.
The refrigerator has been disconnected for a long time.

Food is frozen

The temperature was set too low.
There is „water flow“ noise from inside the refrigerator:
It‘s a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops around the refrigerator casing or door gap:
It‘s a normal phenomenon, the moisture will condense to water when it touches a cold surface of the refrigerator.
The compressor is slightly noisy when starting:

It‘s a normal phenomenon, the noise will be reduced after the compressor works stably. Code F1 displayed:
Possible cause: low voltage to fridge. Adjust the battery protection from High to Medium or from
Medium to Low.
Code F2 displayed:
Possible cause: condenser fan is overloaded. Disconnect power to fridge for 5 minutes & restart. If the code shows again, contact manufacturer for service.
Code F3 displayed:

Possible cause: the compressor starts too frequently. Disconnect power to fridge for 5 minutes & restart. If the code shows again, contact manufacturer for service.
Code F4 displayed:
Possible cause: compressor not kicking in. Disconnect power to fridge for 5 minutes & restart. If the code shows again, contact manufacturer for service.
Code F5 displayed:
Possible cause: overheating of the compressor & electronics. Disconnect power to fridge for 5 minutes & restart. If the code shows again, contact manufacturer for service.
Code F6 displayed:

Possible cause: no parameter can be detected by the controller. Disconnect power to fridge for 5 minutes & restart. If the code shows again, contact the manufacturer for service.
Code F7 or F8 displayed:
Possible cause: temperature sensor is faulty. Contact manufacturer for service.

TECHNICAL INFORMATION

Due to product improvement, the technical information might be different from actual information. Please refer to the rating label on the product.

WARRANTY CONDITIONS

Reimo Reisemobil-Center GmbH, Boschring 10, D-63329 Egelsbach (hereinafter referred to as “Reimo” or “we”), provides a three-year warranty on the products sold under its own “MC CAMPING” brand in addition to the statutory rights related to defects.
The warranty period will start to run on the relevant invoice date. The geographical scope of our warranty extends to the territory of the Federal Republic of Germany.
If any material defects or manufacturing defects are found in your purchased products during the warranty period, we will provide you with one of the following services at our discretion as part of the warranty:

We will repair the goods free of charge; or
We will exchange the goods for an equivalent product free of charge.
Reimo will acquire ownership of any original parts that are replaced within the scope of the above warranty services. You will acquire ownership of the new parts or replacement parts. Any repairs or replacements provided under the warranty will not entitle you to extend or restart the relevant warranty period.

If you wish to make a warranty claim, please contact the dealer from whom you purchased the product in question or Reimo directly as the warrantor:
Reimo Reisemobil-Center GmbH,Boschring 10, D-63329 Egelsbach, Tel.: +49 6150 8662-310
The warranty will not apply if any defects other than material defects or manufacturing defects are found. Furthermore, warranty claims will be rejected if any damage is caused by:

normal wear and tear;
improper and non-intended use of the product;
improper operation, installation, assembly, commissioning or operation contrary to the relevant instructions for use and or installation, especially if instructions for maintenance and care or warnings are not observed;

failure to observe any safety precautions;
use of force (e.g. beating);
self-repairs;

use of any non-original parts or any parts not approved by the manufacturer;
environmental factors (e.g. heat, humidity);
circumstances for which the manufacturer is not responsible (e.g. natural disasters, accidents); or

improper transportation.

In order to make a warranty claim, you must allow us to examine the case in question (e.g. by sending us the goods). Please use secure packaging to ensure that the goods are not damaged during transport.
In order to make a warranty claim, you must enclose a copy of the invoice with the shipment of the goods. This will enable us to check whether the warranty conditions are met. If you do not enclose a copy of the invoice, we may refuse to provide services under the warranty. If your warranty claim is legitimate, you will not incur any shipping costs (i.e. we will reimburse you for any shipping costs incurred to send us the goods).

Please note
This manufacturer’s warranty provided by Reimo will not restrict any statutory warranty rights that you may be able to assert against Reimo / a dealer in the event of defects; you may exercise the relevant rights free of charge. This manufacturer’s warranty shall have no bearing on any statutory warranty rights that you may hold against Reimo. On the contrary, this manufacturer’s warranty serves to consolidate your legal position.
If any of your purchased items are defective, you may always assert your statutory warranty rights against Reimo, regardless of whether the defects are covered by the warranty or whether a claim is asserted under the warranty.

DISPOSAL

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being. When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposals at least free of charge.

Documents / Resources

Mc CAMPING MC-65L Compressor Built in Refrigerator [pdf] Instruction Manual
MC-65L, MC-65L Compressor Built in Refrigerator, MC-65L, Compressor Built in Refrigerator, Built in Refrigerator, in Refrigerator, Refrigerator

References

User Manual

Mc CAMPING MC-65L Compressor Built in Refrigerator

Product Information