MAYTAG MFES4030R Electric Free Standing Ranges
Product Specifications
| Dimension | Value (in) | Value (cm) |
|---|---|---|
| Overall Height (minimum) | 46.48 | 118.06 |
| Overall Width | 29.87 | 75.88 |
| Overall Depth Including Handle | 28.06 | 71.29 |
| Cooktop Height | 35.83 | 91.02 |
| Door Height | 22.29 | 56.62 |
| Drawer Height | 10.33 | 26.23 |
| Depth without Handle | 26.08 | 66.24 |
| Depth with Handle | 28.06 | 71.29 |
| Depth with Door Fully Open | 46.77 | 118.80 |
| Door Top Height | 34.11 | 86.65 |
| Handle Top Height | 33.43 | 84.90 |
| Drawer Height | 11.21 | 28.47 |
Product Usage Instructions
- Location Requirements:
- Observe all governing codes and ordinances.
- To eliminate the risk of burns or fire by reaching over heated surface units, avoid cabinet storage space above the surface units.
- Installation Guidelines:
- Installer must comply with installation clearances specified on the model/serial/rating plate.
- Range should be conveniently located in the kitchen.
- Recessed Installation:
- Recessed installations must completely enclose the sides and rear of the range.
- Electrical Requirements:
- Grounded electrical supply is required for operation.
FAQs
- Q: Can cabinet storage be located above the surface units?
- A: It is recommended to avoid cabinet storage above the surface units to reduce the risk of burns or fire.
- Q: Where can I find the model/serial/rating plate?
- A: The model/serial/rating plate is located on the frame behind a top corner of the door or either side of the drawer.
- Q: Is an anti-tip bracket necessary for installation?
- A: Yes, the anti-tip bracket must be installed for safety. Refer to the “Install Anti-Tip Bracket” section for instructions.
“`
Documents / Resources
 |
MAYTAG MFES4030R Electric Free Standing Ranges [pdf] User Guide MFES4030R, MFES4030R Electric Free Standing Ranges, Electric Free Standing Ranges, Free Standing Ranges, Standing Ranges |