Matt E EVU-2-32-TP-R Three-Phase Connection Unit
The EVU-2-32-TP-R from matt:e is a simple, single dedicated connection unit with built-in O-PEN technology, which allows for the connection of 2 x 32 amp TPN EV charge points to the existing PME earthing facility. The unit incorporates a 5-pole isolator with built-in UV release that disconnects all poles including CPC in the event of a fault, manually resettable in line with BS: 7671, 2018 Amendment 1 2020 Regulation 722.411.4.1 (iii) The O-PEN technology does not require earth rods or measuring electrodes to function correctly.
Specifications
- Description: Three-phase connection unit with 2 x 32amp TPN RCBOs
- Input Volts: Nominal input voltage three-phase 400V 50Hz
- Max Load: 32 amps per load
- Cable Entry Facility: Top and bottom
- Terminal Capacity: Supply 50.0 mm2, Load 25.0 mm2
- Dimensions (H x W x D): 550mm x 360mm x 140mm
- Weight: Approximately 10kg
- Enclosure: Mild Steel Powder Coated
- Ingress Protection: IP4X
- Warranty: 1 year from the date of purchase, limited to the replacement of faulty components
Product Features
- Built-in O-PEN technology
- Standard mild steel IP4X enclosure
- NO EARTH ELECTRODES REQUIRED
Phase loss protection
- Built-in 5 pole mains isolator with manually resettable UV trip.
- Standard 1 Year parts warranty
- Simple wire in wire out the connection
- With 2 x 32amp TPN RCBOs
- Designed and Built in the UK
Dimensions and Specifications
- Description Dedicated EV connection center
- Input Volts Nominal input voltage three-phase 400V 50Hz
- Max Load 32 amps per load
- Cable Entry Facility Top and bottom
- Terminal Capacity Supply 50.0 mm2
- Load 25.0 mm2
- Dimensions ( H x W x D ) 550mm x 360mm x 140mm
- Weight Approximately 10kG
- Enclosure Mild Steel Powder Coated
- Ingress Protection IP4X
Warranty The matt:e
EVU-2-32-TP-R is guaranteed for 1 year from the date of purchase. This warranty is limited to the replacement of faulty components only.
Installation
- Ensure power is switched off before installation.
- Mount the EV connection unit in a suitable location using appropriate hardware.
- Connect the cables to the designated terminals based on the provided terminal capacity.
- Securely close the enclosure after installation is complete.
Connection
- Verify the input voltage matches the unit’s specifications.
- Connect the EV charging equipment to the unit following manufacturer guidelines.
Maintenance
Regularly inspect the unit for any signs of damage or wear. Clean as needed to ensure optimal performance.
FAQs
Q: What should I do if the unit is not functioning?
A: Check the power supply, connections, and circuit breakers. If issues persist, contact customer support for assistance.
Q: Can I install this unit outdoors?
A: The unit is designed for indoor use. Installing it outdoors may void the warranty and expose it to environmental damage.
…Simplifying EV connection
t: 01543 227290 e: info@matt-e.co.uk w: www.matt-e.co.uk
Matt:e Ltd, Unit 5 Common Barn Farm Tamworth Road Lichfield WS14 9PX.
Documents / Resources
 |
matt E EVU-2-32-TP-R Three Phase Connection Unit [pdf] Owner's Manual EVU-2-32-TP-R Three Phase Connection Unit, EVU-2-32-TP-R, Three Phase Connection Unit, Connection Unit, Unit |