ARD-1-63 ARD Connection Unit
“
Product Information:
Specifications:
- Input Volts: 400V 50Hz
- Max Load: 63amps
- Cable Entry: Top and bottom
- Facility Terminal Capacity: 25mm2
- Dimensions (H x W x D): 550mm x 360mm x 120mm
- Weight: Approximately 7kg
- Enclosure: Mild Steel Powder Coated
- Ingress Protection: IP4X
- Warranty: 1 Year
Product Usage Instructions:
Installation:
- Ensure power supply is turned off before installation.
- Mount the ARD connection unit securely in a suitable
location. - Connect the input cables to the designated terminals based on
the specified capacity. - Securely close the enclosure to ensure proper protection.
Operation:
- Turn on the power supply to the unit.
- Ensure all connections are secure and properly installed.
- Monitor the unit for any abnormal behavior or
malfunctions.
Maintenance:
- Regularly inspect the unit for any signs of damage or
wear. - Clean the unit and surrounding area to prevent dust
accumulation. - If any issues are detected, contact a qualified technician for
repairs.
FAQ:
Q: What is the purpose of the auto reset isolator in the ARD
connection unit?
A: The auto reset isolator helps to automatically disconnect
power in case of an overload or short circuit, providing enhanced
safety and protection.
Q: How can I ensure compliance with BS:7671 regulations using
this product?
A: The ARD connection unit is designed to facilitate compliance
with BS:7671 regulations, specifically Amendment 2 of 2018 and
Regulation 722.411.4.1.(iii) of 2022, by incorporating necessary
safety features and specifications.
Q: Is it possible to extend the warranty period for the
product?
A: Currently, the product comes with a standard 1-year warranty.
For any warranty extension inquiries, please contact matt:e Ltd
directly through the provided contact information.
“`
ARD-1-63-TP-R-SPD
Three-phase connection unit with auto rest isolator, Type 2 SPD, and 1 x 63A TPN Type A RCBO
The matt:e ARD connection centres with unique 5 pole auto reset device and built in Type 2 SPD.
Simple to install, dedicated EV connection centres with built in O-PEN® technology that allows for the connection of EV charge points to the PME earthing facility without the use of earth electrodes.
Helping to facilitate compliance with BS:7671. 2018 Amendment 2, 2022 Regulation 722.411.4.1.(iii).
Product Features and benefits · Built in O-PEN® technology · NO EARTH ELECTRODES REQUIRED · Helps reduce disruptive and costly groundworks · Removes the risk of striking buried services · Simple wire in wire out connection · Complete with Type 2 SPD · With built in 63A TPN Type A RCBO · Mild steel IP4X enclosure · Standard 1 Year parts warranty.
Specifications Input Volts Max Load Cable Entry Facility Terminal Capacity Dimensions ( H x W x D ) Weight Enclosure Ingress Protection Warranty
400V 50Hz 63amps Top and bottom 25mm2 550mm x 360mm x 120mm Approximately 7kG Mild Steel Powder Coated IP4X 1 Year
T: 01543 227290 | E: info@matt-e.co.uk | W: www.matt-e.co.uk matt:e Ltd, Unit 1 Langley Brook Business Park, Middleton, Tamworth B78 2BP
…Simplifying EV connection
Documents / Resources
 |
matt E ARD-1-63 ARD Connection Unit [pdf] Owner's Manual ARD-1-63-TP-R-SPD, ARD-1-63 ARD Connection Unit, ARD Connection Unit, Connection Unit |