Marathon Lighting logo

INSTALLATION INSTRUCTIONS FOR EMERGENCY LIGHTING


Package Contents
Part Description Quantity
1 Emergency Lighting 1
2 Hardware Kit 1

EXIT

Warnings and Cautions

IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS

  1. Review the diagrams thoroughly before beginning.
  2. All electrical connections must be in accordance with local codes, ordinances and the National Electric code.
  3. Disconnect power at fuse or circuit breaker before installing or servicing.
  4. Do not use outdoors.
  5. Do not mount in hazardous locations, or near gas or electric heaters.
  6. Do not let power cords touch hot surface.
  7. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.
  8. The use of accessory equipment not recommend by the manufacturer may cause an unsafe condition.
  9. Do not use this equipment for other than intended use.
  10. All servicing should be performed by qualified personnel only.
  11. Allow battery to charge for 24 hours before first use.

SAVE THESE INSTRUCTIONS

Use Flexible Conduit Only
Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting 0

NOTE: First turn off electricity.

Wall mounting (Max. mounting height: 13.9ft)

1. Knockout in back of mounting plate and push wires through the hole.

Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting 1

a: Mounting Plate

2. Securely attach mounting plate to J-box (not provided).

Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting 2

3. ELECTRICAL CONNECTIONS

Make the proper supply wire connections.

If using 120VAC, connect the black and White wires to the building utility.

If using 277VAC, connect the Orange and White wires to the building utility.

Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting 3

a: Black 120VAC INPUT
b: White Neutral
c: Orange 277VAC INPUT

4. Connect the battery to connector on the PCBA.

Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting 4

a: PCB
b: Battery
c: Battery plug

5. Snap fixture onto mounting plate and ensure no wires are pinched. Make sure unit is fully attached.
6. Restore power and press test button. Battery powered LED will come on, AC light will turn off.

Ceiling Mounting

1. Open top cover and knockout on the top of fixture.
2. Secure the mounting plate to tube with nut.
3. Push the wires through the hole for ceiling mounting.

Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting 5

4. Reference step 4-6 in wall mounting above for ceiling mounting.

Marathon Lighting logo

© 2023 Marathon Lighting, Inc. All rights reserved.   T : 214-702-2818    www.marathon-lighting.com

Documents / Resources

Marathon Lighting ML-EM-Combo-2R-WH Emergency Exit Lighting [pdf] Installation Guide
ML-EM-Combo-2R-WH Emergency Exit Lighting, ML-EM-Combo-2R-WH, Emergency Exit Lighting, Exit Lighting, Lighting

References

Leave a comment

Your email address will not be published. Required fields are marked *