M5Stack Plus2 ESP32 Mini IoT Development Kit Instruction Manual

M5Stack Plus2 ESP32 Mini IoT Development Kit.webp

 

Factory Firmware

When the device encounters operational issues, you can try re-flashing the factory firmware to check if there is any hardware malfunction. Refer to the following tutorial. Use the M5Burner firmware flashing tool to flash the factory firmware onto the device.

FIG 1 Factory Firmware.jpg

 

FAQ

Q1: Why is my M5StickC Plus2 black screen/won’t boot?

FIG 2.jpg

 

Solutions: M5Burner Burn official Factory Firmware“M5StickCPlus2 UserDemo”

FIG 3.jpg

 

FIG 4.jpg

 

Q2: Why it working time only 3 hours? Why does it 100% charge in 1 minute, remove the charging cable it will turn off?

FIG 5.jpg

 

FIG 6.jpg

 

Solutions:“Bruce for StickC plus2”This is an unofficial firmware. Flashing unofficial firmware can void your warranty, cause instability, and expose your device to security risks. Proceed with caution.

Please burn back official firmware.

FIG 7.jpg

 

 

1. Preparation

Refer to the M5Burner tutorial to complete the firmware flashing tool download, and then refer to the image below to download the corresponding firmware.

Download link: https://docs.m5stack.com/en/uiflow/m5burner/intro

FIG 8.jpg

 

2. USB Driver Installation

Driver Installation Tip
Click the link below to download the driver matching your operating system. The driver package for the CP34X (for the CH9102 version) can be downloaded and installed by selecting the installation package corresponding to your operating system. If you encounter issues with program download (such as timeout or “Failed to write to target RAM” errors), try reinstalling the device driver.

CH9102_VCP_SER_Windows

https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/drivers/CH9102_VCP_SER_Windows.exe

CH9102_VCP_SER_MacOS v1.7

https://m5stack.oss-cn-shenzhen.aliyuncs.com/resource/drivers/CH9102_VCP_MacOS_v1.7.zip

Port Selection on MacOS

On MacOS, there may be two available ports. When using them, please select the port named wchmodem.

 

 

3. Port Selection

Connect the device to the computer via a USB cable. After the driver installation is complete, you can select the corresponding device port in M5Burner.

FIG 9.jpg

 

4. Burn
Click “Burn” to start the flashing process.

FIG 10 Burn.jpg

 

FIG 11 Burn.jpg

 

Read More About This Manual & Download PDF:

Documents / Resources

M5Stack Plus2 ESP32 Mini IoT Development Kit [pdf] Instruction Manual
ESP32-PICO Mini IoT Development Kit, ESP32-PICO IoT Development Kit, Plus2 ESP32 Mini IoT Development Kit, Plus2 ESP32, Mini IoT Development Kit, Development Kit, Kit

References

Leave a comment

Your email address will not be published. Required fields are marked *