Instruction Manual for Chuang models including: V016, V016 Watch Wireless Charger, Watch Wireless Charger, Wireless Charger, Charger
Shenzhen Chuang Wei Da Technology Co., LTD V016 2A3WR-V016 2A3WRV016 v016
Watch wirVe0le1s6s charger Product Manual 0 Product Introduction Thanks for choosing us! This is a magnetic wireless charger. It Is suitable for iwatch with wireless charging function. Please read the manual carefully before using the product.and keep properly for checking Product Size o -T Y p E c I u s B A 1 2 m m 2 m m - o - 5 ) -b o} 8 E E -o Using Method Oconnect the wireless charger to the power source 6 Place the watch on the wireless charger, ensuring that the center of the back of the watch aligns with the center of the wireless charger. 0 Confirm that the charging indicator light is on, indicating that the watch is chaging Product Specification Model V016 Input DC 5V/1A; DC 5V/2A Output 3.5W Frequency 300-350KHz Product Size R28mm*8mm Attention Please note that when using a wireless charger, it is necessary to ensure that the charging device is in the correct position and avoid items such as protective cases and signal lights on the back of the watch that may affect the charging effect RoHS@ Made in Ch, na FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.Corel PDF Engine Version 17.0.0.491