Instruction Manual for DIGITUS models including: DN-PMS-36IEX-3F32A-V, DN-PMS-36IEX-3F32A-V Rack Power Distribution Units, DN-PMS-36IEX-3F32A-V, Rack Power Distribution Units, Power Distribution Units, Distribution Units, Units
DANGER HAZARD OF ELECTRIC SHOCK. EXPLOSION, OR ARC FLASH · Some outlet terminals have voltage on them when the LED is off. · Disconnect the load power cord from this product prior to servicing the load equipment or the power cord. · Always use a properly rated voltage sensing device to confirm that the power is off. Failure to follow these instruc ons will result in death or serious injury. Rack PDUS with Switched outlets only Switch one pole of the rack PDU outlet. Depending on the input wiring configura on. the unswitched terminal of the outlet may have voltage on when the outlet LED IS off. NOTICE EQUIPMENT DAMAGE HAZARD The ambient opera ng temperature of a closed or mul -unit rack environment may be greater than the ambient temperature of the room. Ensure the ambient opera ng temperature of your rack environment does not exceed the rated ambient opera ng temperature for the Rack PM. Failure to follow these instruc ons can result in equipment damage. Rack Power Distribu on Units INSTALLATION INSTRUCTIONS SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS This manual contains instruc ons and warnings that should be followed during the installa on, opera on, and storage of this product. Failure to follow these instruc ons and warnings will void the product warranty. · This PDU provides convenient mul ple outlets, but it DOES NOT provide surge or line noise protec on for connected equipment. · This PDU is designed for indoor use only in a controlled environment away from excess moisture, temperature extremes, conduc ve contaminants, dust or direct sunlight. · Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that eliminate the connec on to the ground. · The power requirement for each piece of equipment connected to the PDU must not exceed the individual outlet's load ra ng. · The total power requirement for equipment connected to the PDU must not exceed the maximum load ra ng for the PDU. · Do not drill into or a empt to open any part of the PDU housing. There are no userserviceable parts inside. · Do not a empt to modify the PDU, including the input plugs and power cables. · Do not a empt to use the PDU if any part of it becomes damaged. · Do not a empt to mount the PDU to an insecure or unstable surface. · Never a empt to install electrical equipment during a thunderstorm 1- Receiving and unpacking 1.1- Check for shipping damage Upon receipt, immediately inspect the package and report any damage to the carrier. Before installing, inspect the product for damage, confirm there are no missing parts, and report any issues to your Vericom representa ve. 1.2- Make sure all parts are received Op on 2: Fix the bu on mounts on your desired posi on (note the nuts to fix the bu on can move along the PDU), then mount the PDU into the bu on mount holes of your rack. 1.3- List of parts Item Rack 0U PDU Toolless Moun ng Brackets Moun ng brackets + (4) screws Bu on mount + (2) screws Bu on Mount bracket + (2) screws Quan ty 1 2 2 2 2 2- Moun ng 2.1- Ver cal Rack installa on Op on 1: Insert the toolless moun ng brackets into the ends of the PDU (note the brackets can face all four sides of the PDU; be sure to insert them so that the outlets face the desired direc on), then mount PDU to rack rails using user supplied moun ng hardware. Op on 3: Screw the brackets on your desired posi on (note the nuts to fix the bu on can move along the PDU), then mount the PDU to the rack rails using the user supplied moun ng hardware. Op on 4: Fix the bu on mounts on your desired posi on (note the nuts to fix the bu on can move along the PDU), then mount the bracket into the bu on mount holes of your rack.Corel PDF Engine Version 23.0.0.363