Installation Guide for TCS Basys models including: TS3020 Room Mount Averaging Temperature Sensors, TS3020, Room Mount Averaging Temperature Sensors, Averaging Temperature Sensors, Temperature Sensors, Sensors
TS3020 | TCS Basys
Sensor Wiring. Connect the averaging sensors to a UbiquiSTAT's T1 port, wired together in series to achieve averaging of the temperature zones between them.
File Info : application/pdf, 1 Pages, 339.69KB
DocumentDocument| Installation Guide Room-Mount Averaging Temperature Sensors TS3020, TS3030 TS3020 Two-Zone Averaging Kit TS3030 Three-Zone Averaging Kit Mounting Averaging sensor mounting location(s) should be on an interior wall which reflects the average room temperature, about five feet above the finished floor. Avoid unventilated locations and areas exposed to direct sunlight, unusual heat sources, windows and open doors. 1.75 (44.4) 0.72 (18.3) 3.50 (88.9) Attach the mounting plate directly to block or drywall, using the included mounting screws and anchors. After completing the wiring, attach the front housing to the mounting plate using the two embedded hex screws and included Allen wrench. Insert the Allen wrench through the holes on the front of the sensor. Turn each Allen wrench counter-clockwise to bring the halves together T T OVR GND Sensor Wiring Front View Side View Mounting Plate Circuit Board Connect the averaging sensors to a UbiquiSTAT's T1 port, wired together in series to achieve averaging of the temperature zones between them. NOTE: The sensors in the TS3020 and TS3030 kits are averaging sensors for use in multiple zones. They are NOT interchangeable with the TS3000 sensor, which is for use in a single zone. T1 T1 R W1 W2 Y1 Y2 G B/O TC AO1 AO2 GND A B REF + 24V DI1 DI2 DI3 GND T1 T2 T3 +P AI1 AI2 GND UbiquiSTAT TS3020 Two Zones TS3030 Three Zones NOTE: Averaging sensors are non-polarity sensors. Wiring colors in diagrams are for illustrative purposes. 2800 Laura Lane · Middleton, WI 53562 | 800.288.9383 | www.tcsbasys.com | 202305