Levitating Bluetooth Speaker User's Manual

Magnetic Levitation Product Operating Instructions

Thank you very much for buying this product! Follow the instructions below and you will have a magical and amazing experience!

Product List

• 1 suspension bracket
• 1 floating flower ball
• 1 power adapter
• 1 copy of manual
• 1 auxiliary tool

Operation Guidance

1. Plug in: Connect the power adapter to a power outlet and the DC hole of the frame.

   Please place the product on a level table. If the table is uneven, the suspended material may not be able to levitate.

2. Suspension support: With your hand on the suspended object and your fingers apart, gently pull down on top of the ball.

   The weight of the levitating handle rests on the flower.

3. Auxiliary means: Pull it just the right distance and it'll levitate.

4. Power adapter: With auxiliary tools, gently pull out the tool after successful suspension.

   As shown in Figure 3, the suspended object can begin to rotate by gently stirring the top of the suspended object with the hand.

Conditions that may cause suspended matter not to be suspended

• Table shaking
• Table tilt
• Product no power (power supply)
• The weight of the levitating handle rests on the flower

Important Notes

• This is a touch switch identifier. Those with this logo [power-symbol] on the outer frame have touch switches. The light is on or the light is off.
• Bluetooth name: CXF-06
• The light source of this lamp is not replaceable. Please do not disassemble this product yourself, otherwise it will cause damage to the product, and even can not be suspended.
• Indoor use only. Do not place on a slope of no more than 6 degrees.
• Do not use this product in a humid environment.
• If you do not use this product for a long time, please disconnect the power supply.
• Children under the age of 14 must be supervised by an adult.
• Please use the power adapter that comes with the product. If you use another power adapter, select a 12V1A certified power supply.
• Astigmatism people and children should not look at the product light source for a long time.

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

To maintain compliance with FCC's RF Exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. Use only the supplied antenna.