User Manual for DASAN ELECTRON models including: DWD-1000 Wireless Dect Usb Dongle, DWD-1000, Wireless Dect Usb Dongle, Dect Usb Dongle, Usb Dongle, Dongle
DASAN ELECTRON CO., LTD DWD-1000 WF2DWD-1000 WF2DWD1000 dwd 1000
User's Manual WIRELESS DECT USB DONGLE Model Name : DWD-1000 DASAN ELECTRON CO,. LTD. Button & LEDs LED Colors : Green, Red, Blue, Purple USB C-Type Registration Process 1. Connect to PC. 2. Press Base center button during 3 seconds, 3. Base Blue LED is blinking => Pairing mode 4. Press Headset mute button during 3 seconds, then blue LED is blinking => Paring mode If paring is completed, base LED changed to Green and Headset LED is turned off. Call Function 1. Hook Off : Press the Hook button your DECT headset and Blue LED will be light up. 2. Mute On : Press the button during call status and Red LED will be light up. (Mute Off : Press the button again and Blue LED will be light up.) LED Operaion DWD-1000 Status Idle (No Headset Registered) Idle (Headset Registered) Pairing Mode Incoming Call Hook Off Call Mute Microsoft Teams On LED Status Red LED Blinking(0.5 sec) Green LED On Blue LED Blinking (0.25sec) Green LED Blinking (0.5sec) Blue LED On Red LED On Pupple LED On Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi tions: (1) This device may not cause harmful interference, and (2) this device must accept any interf erence received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital dev ice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protectio n against harmful interference in a residential installation. This equipment generates, uses and can r adiate radio frequency energy and, if not installed and used in accordance with the instructions, ma y cause harmful interference to radio communications. However, there is no guarantee that interfere nce will not occur in a particular installation. If this equipment does cause harmful interference to r adio or television reception, which can be determined by turning the equipment off and on, the use r is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement : This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The SAR was tested for the device in thebody worn mode. And it can meet the SAR limit of FCC. Warranty CardAcrobat Distiller 17.0 (Windows)