Sylvan Architectural Hardware
Installation Guide for sylvan models including: Noventa Series, Noventa Series Dummy Trim Lever Satin Nickel Plated, Dummy Trim Lever Satin Nickel Plated, Lever Satin Nickel Plated, Nickel Plated, Plated
File Info : application/pdf, 1 Pages, 354.73KB
DocumentDocumentLever Furniture 1 Deciding on backset (Backset is the distance between the centre of the lever handles back plate to the edge of the door). Normally 60mm backset is used for levers. 70mm backset is used for knobs. Noventa Series Dummy Trim 2 Mark position on door Hold template over edge using either 60mm or 70mm backset. 3 Drill door 2 x 3mm holes into front door face (ONLY 15mm DEEP). Door edge Mark holes on front of door using template 4 Fit handle/knob 1. 2. a 3. c b c Remove grub screw (a) from inside of handle and remove handle (b) and outer rose (c) from inner rose. Screw inner rose to door using pre-drilled holes as a guide b a Reinstall outer rose (a), lever handle (b) and grub screw (c) to inside of lever handle Residential Door Hardware Warranty Sylvan residential door hardware products are covered by the following warranty. * 10 year mechanical. * 5 year finish (see exclusions below). Subject to the following conditions: If a finish or mechanical defect occurs within the warranty period, simply return the product together with proof of purchase to the point of purchase.Upon receipt of defective product it will be either repaired or replaced free of charge.This warranty only applies to the original user of the product, and is non transferable. The Sylvan residential door hardware warranty excludes the following: Indirect or consequential loss or damage · Cost of removal and or replacement · Cost of freight and or travel time · Improper installation or failure to follow fitting instructions · Abuse or misuse of the product · Use of the product for the purpose which the product was not designed · Scratchesfrom keys/rings, abrasions or deterioration due to use of paint, solvents or other chemicals · Use of the product in exposed coastal or geothermal conditions ·The plated finishes of Polish Brass and Black Nickel are classified as soft finishes. As deterioration is possible under some climatic conditions, these finishes are excluded from this warranty. For 70mm backset fold here For 60mm backset fold here Centre line for Knob/Handle 43mm B/C 18 to 25mm hole, 3mm deep ONLY 3mm holes x 2 NOTE: Only 15mm deep P: +64 9 444 5359 F: +64 9 444 3972 sales@gdrutter.co.nz www.sylvan.co.nz SYLNOVDT0003 Installation Template