Instructions for 3DSIMO models including: 3DSIMO, BASIC 2
service cover access you can easily maintain your 3DSIMO Basic 2 1. open service cover with service key 2. remove all grinded material and dust, then put cover back onto Basic 2 ADULT SUPERVISION insertion of material Turn-on the Basic 2. Device is fully preheated once the LED bar is full. Pull out the material.
set contains 3DSIMO BASIC 2 service key USB charging cable PCL meterial set contains 3DSIMO BASIC 2 service key USB charging cable PCL meterial 3DSIMO - BASIC 2 INSTRUCTION MANUAL Charge your device before first use 3DSIMO - BASIC 2 INSTRUCTION MANUAL Charge your device before first use extrusion (feed) button controls and elements retraction (pull-back) button power switch filament inlet opening charging port service cover nozzle service cover lock LED status bar extrusion (feed) button controls and elements retraction (pull-back) button power switch filament inlet opening charging port service cover nozzle service cover lock LED status bar service cover access insertion of material ejection of material ADULT SUPERVISION you can easily maintain your 3DSIMO Basic 2 1. open service cover with service key 2. remove all grinded material and dust, then put cover back onto Basic 2 service cover access Turn-on the Basic 2. Device is fully preheated once the LED bar is full. Insert material into filament opening. Once you feel pressure, go to another step. press retraction button and wait until the LED bar is off. Pull out the material. If you feel tension, repeat this step three times. press retraction button again. keep in mind, that ejection of material is possible only when the device is preheated. charging hold extrusion button and check if your material is feeded into the nozzle. After a while, you will see material going out of the nozzle. Plug the Micro USB cable into charging port. Check that LED bar shows charging sequention status. Once the charging is done, LED bar show you, that charging process is done. If the charging sequence does not start after connecting the charging cable, the cable must be disconnected and the device must be switched off and on several times. charging sequention status charging done insertion of material ejection of material ADULT SUPERVISION you can easily maintain your 3DSIMO Basic 2 1. open service cover with service key 2. remove all grinded material and dust, then put cover back onto Basic 2 Turn-on the Basic 2. Device is fully preheated once the LED bar is full. Insert material into filament opening. Once you feel pressure, go to another step. press retraction button and wait until the LED bar is off. Pull out the material. If you feel tension, repeat this step three times. press retraction button again. keep in mind, that ejection of material is possible only when the device is preheated. charging hold extrusion button and check if your material is feeded into the nozzle. After a while, you will see material going out of the nozzle. Plug the Micro USB cable into charging port. Check that LED bar shows charging sequention status. Once the charging is done, LED bar show you, that charging process is done. If the charging sequence does not start after connecting the charging cable, the cable must be disconnected and the device must be switched off and on several times. charging sequention status charging doneAdobe PDF library 15.00 Adobe Illustrator(R) 24.0